System Test - IntelliSense SECURIT 900C User Manual

SYSTEM TEST

CHIME
LOGS
SYSTEM TEST
Periodically it is advisable to check that the system is working
correctly and to check that the sensors are communicating with the
panel. These tests should be performed at least every 3 months.
To do this, go to a keypad, enter a user code then press 5. The
outside bell will sound and all of the zone LEDs will light for 5
seconds. The strobe will continue to flash while the test is in
progress.
When any sensor is activated or a door fitted with a contact is
opened, the internal speaker will give two beeps. The zone light will
illuminate until the test is cancelled. Proceed to the next zone until
you have completed testing all the zones. Return to the keypad - all
zones that have responded will be illuminated.
To Cancel, enter a user code and wait for two beeps.
CHIME
The control panel offers the ability to have chime on a zone when
unset. This feature will emit two beeps via the internal speaker and
keypad buzzer whenever a zone is activated.
To enable chime enter the user code, press the 9 key and the
number key that represents the zone(s) you want on chime. The light
for the zone will illuminate. Press * to accept the zones on chime.
To remove chime on all zones enter the user code, press the 9 and
* keys.
LOGS
The user has the ability to look at a log of the last 16 alarms. This is
useful if the panel has been reset and you need to find the zone that
caused the alarm.
Enter a user code, then 0.
The most recent alarm is displayed first with a single bleep, then
stepping through each events automatically.
6