Choosing A Standard Setting - Meridian 818 User Manual

30
Configuring the 818

Choosing a standard setting

Reference Audio Core
The 818 provides two standard settings, called Types,
which configure all aspects of the 818 into standard
configurations.
These standard Types are shown in the following table:
Type
1
2
In addition, your installer may have provided one or
more named User Types, with settings appropriate to
the configuration of equipment when your 818 was
installed.
You can reset the configuration of the 818 to any of
these Types to restore it to the state it was in when
it was installed. Note: Selecting a Type will clear any
configuration changes you have made.
To select a standard setting
Warning: this procedure will reset any
configuration changes you have made.
• Switch off any power amplifiers that are connected to
the 818 and put any digital speakers into standby.
Put the 818 into standby by pressing Off (front panel
•
or remote).
Press and hold down Volume + (under the front
•
panel).
The display shows:
• Keep holding down Volume + for a further three
seconds.
The display shows:
Label Description
Fixed Fixed output, for use with Meridian
DSP loudspeakers.
Variable Variable output, for use with power
amplifiers and analogue speakers.
Type in... 3
Type- please wait.
Then after a short delay the display shows the current
Type.
Type 1
For example:
• Press A or V on the front panel to change the Type
number.
Typing, please wait.
The display shows:
• Wait for one second, and then put the 818 into
standby by pressing Off (front panel or remote).
• Switch on again to use the standard settings you
have selected.
Fixed