Measumax 10-125 Operation Manual

1. Functional elements：
1 2 3 4
11
Front view
Part of back view
2. LCD Display：
ABS INC Set
3. Operation：
Two ways of pressing the keys are used in the following illustration:
（1）Press and release；
（2）Press and hold (for more than 2 seconds).
3.1 ON/OFF•••SET key:
Press and release：Will switch the power on/off.
Press and hold (2 sec. or more) ：Will set the origin data for absolute measurement；The "Set" sign will be displayed on LCD.
The origin data of metric measurement can be set to 0, 25, 50, 75 relative to the size of the micrometer
The origin data of inch measurement can be set to 0, 1", 2", 3"relative to the size of the micrometer
The origin data will automatically reset to the default setting after the battery has been replaced.
Default origin data of the micrometer head is 0.
3.2 ABS/INC•••UNIT key: Absolute and incremental measuring conversion. Metric-inch conversion when pressed for a prolonged time.
Press and release：Absolute and incremental measuring mode conversion；
"INC" sign will be displayed on the LCD in incremental measuring mode. When the "INC" is not displayed then
the unit is in absolute measuring mode.
Press and hold (2 sec. or more) ：For Metric/Inch conversion. The"in" sign will be displayed on LCD when the unit is in imperial
mode. If not displayed then the unit is in the metric measuring mode.
3.3 Output data key:
Press and release：The micrometer will output the displayed data and display "
Press and hold (2 sec. or more): The micrometer will output the data and display "
4. Power：
If not used for five minutes, the power will auto-shut off. The micrometer will power up when the
"ON/OFF •••SET" key is pressed or the spindle is turned. The micrometer can be switched off by pressing the "ON/OFF•••SET"
key to save the battery when not in use.
Use an SR44 battery. Replace the battery when the display data is blurred or the "
Remove the battery cap by turning it counterclockwise with a coin or screwdriver.
The new battery must be placed with the positive (+) side up.
Electronic Micrometer
Operation Manual
Models 10-125, 10-126, 10-127, 10-128
5 6 7
8 9 10
in : Inch measuring mode.
INC: Incremental measuring mode.
ABS: Absolute measuring mode.
www.measumax.com
．Frame
1
2．Anvil
3．Spindle
4．Locking device
5．Data output key
6．Friction drive
7．Quick drive
8．ON/OFF•••SET key
12
9．ABS/INC•••UNIT key
10．LCD display
13
11．Frame cover
12．RS232 data output
13．Battery cap
Set : Origin set.
: : Battery voltage is low.
: Data output Transferring
" once.
" continually until the button is pressed
" sign is displayed on the LCD.