Toyota Camry 2001 Owner's Manual page 23

Your vehicle has a wireless remote
control system that can lock or unlock
all the doors, or activate the theft
deterrent system from a distance within
approximately 1 m (3 ft.) of the vehicle.
LOCKING AND UNLOCKING
DOORS
To lock and unlock all the doors, push
the switches of the transmitter slowly
and securely.
To lock: Push the "LOCK" switch. All the
doors are locked simultaneously. At this
time one beep will be heard, and the
parking lights, side marker lights, license
plate lights and tail lights will flash once.
Check to see that the doors are securely
locked.
If any door is not securely closed, locking
cannot be performed by the "LOCK"
switch and a beep will sound continuously
for 10 seconds. However, if the key is in
the ignition, a beep will not sound.
To stop the beep, close all the doors se-
curely or push the "UNLOCK" switch.
'01Camry_U (L/O 0009)
To unlock: Push the "UNLOCK" switch
once to unlock the driver's door alone.
Pushing the switch twice within 3 seconds
unlocks all the doors simultaneously. Each
time the "UNLOCK" switch is pushed, two
beeps will be heard, and the parking
THE
lights, side marker lights, license plate
lights and tail lights will flash twice.
When the "UNLOCK" switch is pressed,
the interior light and/or ignition key light
come on. The light remains on for about
15 seconds unless any door is opened
and closed. (For further information, see
"Interior lights" and/or "Ignition
light" in Section 1−4.)
You have 30 seconds to open a door after
using the wireless remote unlock feature.
If a door is not opened by then, all the
doors will be automatically locked again
and one beep will be heard.
If the "LOCK" or "UNLOCK" switch is kept
pressed in, the locking or unlocking opera-
tion is not repeated. Release the button
and then push again.
2001 MY CAMRY (OM33528U)
SWITCHING BEEP SOUND ON AND OFF
You can switch the beep on and off. (The
beep is on initially and after battery re-
placement.)
To switch the beep on and off:
With the driver's door opened—
1. Insert the ignition key and remove it.
2. Within 5 seconds, insert the ignition
key again and turn it to the "ON" posi-
tion.
3. After 10 seconds, push
"LOCK", "UNLOCK" or "PANIC" button
switch
twice within 10 seconds.
Two beep sounds inform you that the
program has been switched on or off.
If this procedure is not followed exactly,
the beep will not operate as expected.
Check the beep ON/OFF operation by
pushing the transmitter switch after you
finish this procedure. If the beep does not
operate as expected, repeat this proce-
dure from step 1.
the same
15