Table of Contents
Advertisement
Quick Links
Electro-Magnetic Compatibility (EMC)
This product complies with Council Directive 2004/108/EC
when installed and used in accordance with the relevant
instructions.
Service and Technical Support
PLEASE CONTACT YOUR NEAREST DISTRIBUTOR
If unknown then fax: 44 (0) 1453 733322
© Copyright RDS Technology Ltd 2008
Document number
S/DC/500-10-600: Issue 1.0 : 15/5/08
\UK600100.DOC
User Guide
A100
GPS Receiver
Installation
1
Advertisement
Table of Contents
Summary of Contents for RDS A100
-
Page 1: User Guide
Service and Technical Support PLEASE CONTACT YOUR NEAREST DISTRIBUTOR If unknown then fax: 44 (0) 1453 733322 © Copyright RDS Technology Ltd 2008 Document number S/DC/500-10-600: Issue 1.0 : 15/5/08 \UK600100.DOC User Guide... -
Page 2: Table Of Contents
A100 GPS RECEIVER Contents Introduction____________________________________________3 Parts List – Kit Ref. P/A100-GPS__________________________3 Mounting the antenna___________________________________4 Connections ___________________________________________5 Psi with ASC 200.................... 5 ASC 200 Only....................6 Psi only ......................6 Configuration __________________________________________7 Operation ______________________________________________7... -
Page 3: Introduction
A100 GPS RECEIVER Introduction The RDS A100 GPS Receiver uses SBAS* to enable 50cm accuracy 95% of the time (assuming good reception). It is pre-configured for operation with the PSi head unit and/or the ASC 200 Automatic boom section Controller. -
Page 4: Mounting The Antenna
The antenna can then be repositioned or if necessary, the source of the interference suppressed. If need be, contact RDS for further advice on suppression methods. Secure the antenna cable close to the antenna mounting (using cable ties) so •... -
Page 5: Connections
A100 GPS RECEIVER Connections Psi with ASC 200 S/CB/216-7-006 S/CB/216-7-005 Power Supply 7 – 36 Vdc... -
Page 6: Asc 200 Only
A100 GPS RECEIVER ASC 200 Only Power Supply 7 – 36 Vdc S/CB/216-7-006 Psi only S/CB/216-7-006 S/CB/268-1-045 Power Supply 7 – 36 Vdc... -
Page 7: Configuration
ZDA @ 1Hz (Time and Date) SBAS: EGNOS Baud rate: 19,200 Data Bits: Stop Bits: Parity: None Flow Control : changes configuration done utility ‘TERMINAL1.EXE on a PC. If re-configuration is necessary, please contact RDS Technology Ltd, UK for assistance on how to do this. -
Page 8: Operation
A100 GPS RECEIVER Operation The first startup can take from 5 to 15 minutes depending on the location. Subsequent startups will be quicker. On power-up, the LED on the receiver indicates the following, LED Indication Condition Power On Amber GPS Lock... - Page 9 A100 GPS RECEIVER Issue 1.0: 15/5/08 Original issue...
Need help?
Do you have a question about the A100 and is the answer not in the manual?
Questions and answers