How To Use Your Cordless Stainless Steel Kettle; Descaling - Brabantia BBEK1007 Instruction Manual

HOW TO USE YOUR CORDLESS STAINLESS STEEL KETTLE

1. The Kettle must be in the OFF position (ON/OFF Switch: switch up).
2. Open the lid by pressing the lid button.
3. Do not use hot water to fill the Kettle. Use only fresh cold water. Allow the cold water to run for
three to four seconds before filling the Kettle
4. Ensure that the water is filled to at least the MIN level and do not exceed the MAX level.
5. Place the Kettle onto its power base.
6. Ensure that the lid is properly closed.
7. Connect the mains plug to the mains electrical supply making sure that the voltage and the
frequency is the same as detailed on the Rating Plate found on the power base of the Kettle.
8. To switch the Kettle on, press the On/Off plastic switch down. The indicator light will illuminate
with a RED light.
9. When the water has boiled, the Kettle will switch off automatically.
10. The Kettle may be switched Off at any time by lifting the On/Off switch upwards to the 'Off'
position.
IMPO RTA NT: Switch off the mains electrical supply and remove the mains plug from the mains
supply before removing the Kettle from the Power Base; before moving the Kettle and also when the
Kettle is not in use.

DESCALING

Furring up is a common problem in hard water areas, and it is recommended to descale the Kettle
regularly.
1. To descale, fill the Kettle with 1.7L cold water and add approximately 75ml vinegar.
2. Boil the water and allow to stand overnight.
3. Re-boil the water the next day.
4. Discard the re-boiled water and refill the Kettle with fresh water.
5. Boil the fresh water. This boiled water must also be discarded.
N O TE: Normal commercial descalers for kettles may also be used. Follow the instructions carefully
for the given descaler.
5