Advertisement
WARNING: The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions and
situations that may occur. It must be understood that common sense and caution are factors which must be applied by the operator.
2.
INTRODUCTION
Portable floodlight with adjustable head, housed within a stable steel frame. features 30 super bright sMD LEDs giving a full 120° spread of light.
Weatherproof design with on/off rocker switch. supplied with mains cable. Built in 7.4V 3.0Ah Li-ion rechargeable battery. suitable for lighting
workshops, garages and other environments where no mains supply is available.
Model No: ..................................................................................... LED109c
Battery: .................................................................... 7.4V 3.0Ah Lithium-ion
Lumen Output: ................................................................................. 1200lm
LED:
.............................................................................................30 sMD
Operating Time: ...................................................................................3.5hr
Approximate Charging Time: ................................................................6hr
3. OPERATION INSTRUCTIONS
3.1.
CHARGING
3.1.1. the charging port is at the back of the floodlight behind a rubber flap. A red light above the sMD LEDs denotes charging mode.
3.2.
OPERATION
3.2.1. Position the floodlight in the area which requires illumination.
3.2.2. this LED floodlight develops minimal heat and is not subject to the same restrictions that apply to halogen lamps that become too hot to
touch. We do however recommend that the floodlight should not be placed in cramped or restrictive situations and recommend the
following minimum distances between the floodlight and any surface/object:
• 500mm minimum between the top of the floodlight and any overhead objects.
• 200mm between sides of floodlight and end or side walls, surfaces or objects.
• 1 metre minimum between the front of the floodlight and any object to be illuminated.
3.2.3. to turn the light on press the rocker switch on the back of the floodlight.
3.2.4. to adjust the angle of the floodlight loosen thumb screws on either side and retighten afterwards.
4.
MAINTENANCE
4.1.
Keep floodlight clean and check for damage before every use. If damage is observed, remove from use until it is repaired.
4.2.
Before the unit is disposed of at the end of its life , it is a requirement that the battery is removed. refer to the battery removal section below.
Environmental Protection.
recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
remove the five screws which hold on the glass lens. Pull the sMD unit forward and undo the two screws which hold
the battery cover on. cut the battery wires and remove. Dispose of battery according to local government guidelines.
under the Waste Batteries and Accumulators regulations 2009, Jack sealey Ltd are required to inform potential
purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak's
registered compliance scheme. Jack sealey Ltd's Batteries Producer registration number (BPrn) is BPrn00705.
Parts support is available for this product. to obtain a listing and/or diagram, please log on to: www.sealey.co.uk,
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack sealey Limited
Battery Removal
email: sales@sealey.co.uk or phone: 01284 757500
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park,
Bury st. Edmunds, suffolk,
IP32 7Ar
Original Language Version
WEEE Regulations.
Dispose of this product at the end of its working life in compliance
with the Eu Directive on Waste Electrical and Electronic Equipment.
When the product is no longer required, it must be disposed of in an
environmentally protective way. contact your local solid waste
authority for recycling information.
01284 757500
01284 703534
www.sealey.co.uk
W e b
sales@sealey.co.uk
email
LED109c
Issue: 1 - 15/4/13
Advertisement
