Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Awilco multiplex IP-EFOY-GATEWAY
- Page 1 IP-EFOY-GATEWAY Technical Overview - EN AWILCO-MULTIPLEX Yderholmvej 64 DK-4623 Ll. Skensved Tel.: +45 5656 5400 Fax: +45 5656 5405 mail@awilco-multiplex.dk www.awilco-multiplex.dk REV 1.5.0 - Copyright by Dipl.-Ing. Janus Piwek, Ingenieurbüro Piwek...
-
Page 2: Table Of Contents
Introduction .............................. 4 Firmware update description ........................5 V0.8.3 ............................... 5 V0.7.1 ............................... 5 V0.6.7 ............................... 5 Technical Data ............................6 IP Configuration ............................7 Description Periphery ..........................8 Front panel ............................8 Back panel ............................9 Supported Protocols ..........................10 EFOY PRO Compatibility .......................... - Page 3 Figure 3: Schematic Installation ........................11 Figure 4: IP-Configuration Menu........................12 Figure 5: PC's static IP-Configuration ....................... 12 Figure 6: Login IP-EFOY-GATEWAY website ...................... 13 Figure 7: IP-Configuration IP-EFOY-GATEWAY ....................13 Figure 8: Green Power Supply.......................... 14 Figure 9: Fuel cell power supply for portable applications ................15 Figure 10: Pilot project - Off grid power supply for internet service provider ..........
-
Page 4: Introduction
Table 21: Description event protocol ....................... 32 Introduction The IP-EFOY-GATEWAY serves for remote control of a single SFC EFOY PRO fuel cell over the TCP/IP protocol. At this the entire fuel cell parameter defined by the SFC EFOY PRO technical data sheet are readout continu- ously over the RS232 interface. -
Page 5: Firmware Update Description
Firmware update description V0.8.3 • Firmware supports now SFC EFOY PRO 800/800 DUO and 2400/2400DUO • Dynamic web data update interval on the web site can be adapted V0.7.1 • Firmware supports now SFC EFOY PRO v11.10 with CONFIG command adaptation, but also back- ward compatibility is assured V0.6.7 •... -
Page 6: Technical Data
Technical Data Data Range Comment Power consumption • Input voltage range 8V - 42V Allowed with 12V/24V batteries • Power supply on terminal block and over EFOY PRO data interface as well • Ethernet 10/100BASE-T IEEE802.2 compatibility • RS232 (1 port) Communication EFOY PRO with 9600 Baud Table 1: Electrical Data Data... -
Page 7: Ip Configuration
IP Configuration The following 5 shows the default settings of the IP-EFOY-GATEWAY. By pressing the „Default“ switch button 5 seconds (see Figure 1) you can restore the default setting. DHCP Enabled since firmware version v0.6.7 IP address 192.168.96.210 Subnet mask 255.255.255.0... -
Page 8: Description Periphery
Description Periphery Front panel Figure 1: Front panel Power supply on 1Hz heart beat, system Data communication EFOY Pro ↔ IP-EFOY-GATEWAY Not used Default Switch button must be pressed > 5 seconds, to restore default setting RS232 Communication IP-EFOY-GATEWAY ↔ EFOY PRO •... -
Page 9: Back Panel
Back panel Figure 2: Back panel Ext. Power External power supply 8-42V • Inverse-polarity protection • TVS Diode >54V • Power supply filter Table 6: Description front panel AWILCO-MULTIPLEX ApS | Yderholmvej 64 | DK-4623 Ll. Skensved | Phone: +45 5656 5400 | Fax: +45 5656 5405 mail@awilco-multiplex.dk | www.awilco-multiplex.dk... -
Page 10: Supported Protocols
Supported Protocols Protocol Comment • HTTP Configuration • Fuel cell states • DCHP Client Automatic IP configuration • SNMP v2c Remote control EFOY PRO • SMTP Email notification service • Protocol stack EFOY PRO Communication with EFOY PRO over RS232 •... -
Page 11: Getting Started
Getting started Figure 3 depicts schematically the cabling diagram of the IP-EFOY-GATEWAY to other communication devices and EFOY PRO periphery. Figure 3: Schematic Installation AWILCO-MULTIPLEX ApS | Yderholmvej 64 | DK-4623 Ll. Skensved | Phone: +45 5656 5400 | Fax: +45 5656 5405... -
Page 12: Figure 4: Ip-Configuration Menu
As a start please follow the following steps to set up the network configuration properly. The IP-EFOY- GATEWAY's default IP-Address is “192.168.96.210”. Use your browser on initial installation or after a default reset to access IP-EFOY-GATEWAY's web server. First you have to set up network settings to be conform with your local network. -
Page 13: Figure 6: Login Ip-Efoy-Gateway Website
Open the browser and enter the default IP address of the IP-EFOY-GATEWAY (see Figure 7). Figure 6: Login IP-EFOY-GATEWAY website Choose menu item “IP” on the left of the website and enter the default login and password com- bination (see Figure 6 - Default user name: “admin” and default password: “00000”) Afterwards choose new static IP-Configuration for your given network (see Figure 7). -
Page 14: Use-Case
Use-Case „Green“ Off-Grid 48V „Power Over Ethernet“ power supply for wireless base stations Figure 8: Green Power Supply AWILCO-MULTIPLEX ApS | Yderholmvej 64 | DK-4623 Ll. Skensved | Phone: +45 5656 5400 | Fax: +45 5656 5405 mail@awilco-multiplex.dk | www.awilco-multiplex.dk... -
Page 15: Portable Efoy Pro Power Supply With Umts-Router For Remote Control Applications
Portable EFOY Pro power supply with UMTS-Router for remote control applications Figure 9: Fuel cell power supply for portable applications AWILCO-MULTIPLEX ApS | Yderholmvej 64 | DK-4623 Ll. Skensved | Phone: +45 5656 5400 | Fax: +45 5656 5405 mail@awilco-multiplex.dk | www.awilco-multiplex.dk... -
Page 16: Off Grid Power Supply For Wireless Internet Service Provider (3.5 / 5 Ghz Base Stations)
Off grid power supply for wireless internet service provider (3.5 / 5 GHz base stations) Figure 10: Pilot project - Off grid power supply for internet service provider AWILCO-MULTIPLEX ApS | Yderholmvej 64 | DK-4623 Ll. Skensved | Phone: +45 5656 5400 | Fax: +45 5656 5405 mail@awilco-multiplex.dk | www.awilco-multiplex.dk... -
Page 17: Description Web Interface
Port for TCP-UART-BRIDGE-MODE (1024-65535) • Start/Stop TCP-UART-BRIDGE-MODE • Save settings • IP-EFOY-GATEWAY restart Table 10: Description web site - General AWILCO-MULTIPLEX ApS | Yderholmvej 64 | DK-4623 Ll. Skensved | Phone: +45 5656 5400 | Fax: +45 5656 5405 mail@awilco-multiplex.dk | www.awilco-multiplex.dk... -
Page 18: Web Site - Ip
MAC address IP-EFOY-GATEWAY • Host name IP-EFOY-GATEWAY • DHCP client service enabled/disabled • IP address IP-EFOY-GATEWAY (automatic bound via DHCP) • Gateway in LAN (automatic bound via DHCP) • Subnet mask (automatic bound via DHCP) • Primary DNS Server (automatic bound via DHCP) •... -
Page 19: Web Site - Security
10.3 Web site - Security Figure 13: Web site - Security Note Description • User name • Password(maximum 9 signs) • Password confirmation • Save settings Table 12: Description web site – Security AWILCO-MULTIPLEX ApS | Yderholmvej 64 | DK-4623 Ll. Skensved | Phone: +45 5656 5400 | Fax: +45 5656 5405 mail@awilco-multiplex.dk | www.awilco-multiplex.dk... -
Page 20: Web Site - Snmp
10.4 Web site - SNMP Figure 14: Web site - SNMP Note Description • System name (may be readout via SNMP default OID) • System location (may be readout via SNMP default OID) • System contact (may be readout via SNMP default OID) •... -
Page 21: Figure 15: Web Site - 1St Generation Efoy Supervisor
Figure 15: Web site - 1 generation EFOY Supervisor Figure 16: Web site - 2 generation EFOY Supervisor AWILCO-MULTIPLEX ApS | Yderholmvej 64 | DK-4623 Ll. Skensved | Phone: +45 5656 5400 | Fax: +45 5656 5405 mail@awilco-multiplex.dk | www.awilco-multiplex.dk... -
Page 22: Table 14: Description Web Site - Efoy Supervisor
Note Description • Battery protection – nevertheless the EFOY will charge the battery if the battery voltage fall below the configured voltage and the EFOY operating mode is set to “OFF”, to prevent deep discharge • Selection of EFOY operating mode •... -
Page 23: Web Site - Efoy Setup
10.6 Web site - EFOY Setup The EFOY setup overview makes it possible to set up EFOY PRO fuel cell's configuration. The entire configu- ration is described analogue to the EFOY “Config” request. Some options differ from 1 to 2 EFOY PRO generation. -
Page 24: Figure 18: Web Site - 2Nd Generation Efoy Setup
Figure 18: Web site – 2 generation EFOY Setup Note Description • EFOY switch on voltage for 12V systems in mV • EFOY switch off voltage for 12V systems in mV • EFOY switch off voltage 12V systems in mA •... -
Page 25: Web Site - Efoy Status
Green = IP-EFOY-GATEWAY synchronized with EFOY • Red = IP-EFOY-GATEWAY not synchronized with EFOY • Green = IP-EFOY-GATEWAY no errors on processing EFOY data • Red = IP-EFOY-GATEWAY errors on processing EFOY data • Current EFOY battery voltage in V •... -
Page 26: Table 16: Description Web Site - Efoy Status
Note Description • Temperature at the stack • Temperature in the fuel cell • Temperature at the heat exchanger • Green = methanol level above sensor threshold or no sensor connected • Red = methanol level below sensor threshold • DuoCartSwitch state •... -
Page 27: Web Site - Efoy Errors
10.8 Web site - EFOY Errors Figure 20: Web site - EFOY Errors Note Description EFOY error listing Table 17: Description web site - EFOY Errors AWILCO-MULTIPLEX ApS | Yderholmvej 64 | DK-4623 Ll. Skensved | Phone: +45 5656 5400 | Fax: +45 5656 5405 mail@awilco-multiplex.dk | www.awilco-multiplex.dk... -
Page 28: Web Site - Info
10.9 Web site - Info Figure 21: Web site – 1 generation EFOY Info Figure 22: Web site – 2 generation EFOY Info AWILCO-MULTIPLEX ApS | Yderholmvej 64 | DK-4623 Ll. Skensved | Phone: +45 5656 5400 | Fax: +45 5656 5405 mail@awilco-multiplex.dk | www.awilco-multiplex.dk... -
Page 29: Table 18: Description Web Site - Info
Note Description • Device type IP-EFOY-GATEWAY • Version firmware and hardware • Version web site image • Version TCP/IP Stack • Compile date • Link Web site Ingenieurbuero Piwek • Link Email to Ingenieurbuero Piwek • Connected EFOY will be determined automatically •... -
Page 30: Email Notification Service
10.10 Email Notification Service From firmware versions v0.6.1 on, the IP-EFOY-GATEWAY supports an email notification service to deliver EFOY PRO events and warnings to an email address. From now on service personnel get real-time email fault reports on their smart phone or email account. The service is set up the easy way over the website menu “Notification”... -
Page 31: Figure 24: Email Delivered Successfully
In the following 21 the email notification configuration is described. Field name Description Option Notification Enabled Enables the email notification service mandatory SMTP Server SMTP server used for email delivery. Please consult mandatory your administrator or email provider. Port Port number of the SMTP server. Please consult your mandatory administrator or email provider. -
Page 32: Figure 26: Email Client
Figure 27 depicts all fetched fault report emails in the area marked with „1“. Area „2“ shows the delivered IP-EFOY-GATEWAY emails with the fault report in more detail. 22 illustrates the email fields and the single rows of the fault report. Email subject: IP-EFOY-GATEWAY ALERT. -
Page 33: Tcp-Uart-Bridge-Mode
Remote control over a command line interface is also possible. Figure 26 depicts the opportunity how to establish a remote connection to the IP-EFOY-GATEWAY over terminal software like Hyper term, Tera term. To use this option, a service (TCP Service Port) has to be started first over the web interface. -
Page 34: Off-The-Shelf Snmp Based Monitoring Solution
IP address and of course all products deployed by Ingenieurbüro Piwek. If an EFOY PRO is in error state, or running out of methanol, the IP-EFOY-GATEWAY on the tactical map lights up red. The operator is now able to react very quickly within few minutes. -
Page 35: Figure 29: Live Efoy Pro Graphs Overview
Also, on the tactical map, the IP-EFOY-GATEWAY icon will light up and show the error. By doing so, our per- sonnel can see which fuel cell is in error, what the cause is and what equipment is depending on the fuel cell. -
Page 36: Snmp Efoy Pro Fuel Cell Remote Control
SNMP EFOY PRO Fuel Cell Remote Control Due to SNMP V2C network protocol support of the IP-EFOY-GATEWAY, the system is capable of providing a given set of variables called OIDs, reflecting the EFOY PRO fuel cell's state, to the customers network man- agement system.
Need help?
Do you have a question about the IP-EFOY-GATEWAY and is the answer not in the manual?
Questions and answers