Page 2
Mustang Subwoofer Upgrade (DOES NOT FIT CONVERTIBLE) Installation Instructions KA-10-WOOFER 5. Remove the fuse box cover under the hood and remove the 10mm nut from the main power lug. 6. Connect the power harness to the lug and retighten the 10mm nut. (Do not install supplied fuse yet) Fig.
Page 3
Mustang Subwoofer Upgrade (DOES NOT FIT CONVERTIBLE) Installation Instructions KA-10-WOOFER 13. Remove the lower rear seat cushion by pushing the front edge back and then lifting up. 14. Release and fold down the rear seat backs. 15. Remove the three plastic retainers that secure the quarter panel cover. One retainer is above the floor pan and the other two are located in the pass through area between the cabin and the trunk.
Page 4
Mustang Subwoofer Upgrade (DOES NOT FIT CONVERTIBLE) Installation Instructions KA-10-WOOFER 18. Ground the harness to the 10mm bolt located just below and next to the glove compartment. Fig. 13 19. Run the overlay harness along the bottom of the door and secure with wire ties.
Page 5
Mustang Subwoofer Upgrade (DOES NOT FIT CONVERTIBLE) Installation Instructions KA-10-WOOFER 27. Push the subwoofer toward the outside of the car as far as possible and install the supplied 10mm nut on the factory stud and tighten. Fig. 19 28. Fold about six inches of the trunk liner underneath itself and then tuck the fold under the edge of the subwoofer.