Initializing To Factory Defaults - Whistler WS1065 Owner's Manual

INITIALIZING FACTORY DEFAULTS

Initializing to Factory Defaults

You can initialize the entire scanner to factory defaults.
This clears all programmed data and global settings.
NOTE: You can save your working memory to a
V-Scanner folder before performing this operation.
V-Scanner memory is not affected by this procedure.
To initialize to factory defaults:
1. Turn off the scanner, then turn it on again.
2. When the Welcome/Ownerscreen appears, press
0. The scanner displays:
System Tests:
Select a Test...
Exits if no key
is pressed
3. Press 1. The scanner displays:
Factory Init
Erase Memory
ENTER if APPROVE
CLEAR to EXIT
4. Press ENT. The scanner displays:
File System
Initialized to Defaults.
Press any key.
5. Press any key to proceed. The scanner reboots
with file system and global parameters reset to
factory defaults.
52