• The use of accessory attachments not recommended by strong electromagnetic interference. If this occurs, simply reset the product and resume normal operation by Hamilton Beach may cause injuries. by following the operation manual. If normal operation • To reduce risk of personal injury and to prevent...
Safety Alert Symbols Sanitizing The following safety alert symbols are used throughout this manual to alert you to the Sanitize before first use and after each use with a safety hazards described below. sanitizing solution of1 tablespoon (15 ml) of household bleach per 1 gallon (3.8 liter) of clean, cool water (60°F/16°C), mixed according to the Electrical Shock Hazard...
Parts and Features Ice Hopper Cover Inner Ice Hopper Ice Hopper Alignment Guides Outer Ice Hopper Back of Ice Shaver/Blender Ice Chute Splash Shield Integrated Main Circuit Power Breaker Switch Blender Container (Jar) Control Panel Base Drive Jar Pad Memory Coupling Drain Cover with...
Control Panel Scroll up/down buttons Serving Size Buttons A–D Press the L or M button to Press A–D to select the scroll through status and desired serving size. diagnostic messages. START button PULSE button Starts operation Blender jar must of the selected be in place.
Page 7
19 L max. Automatic operation: Manual operation: Select serving size: 600 mL SELECT SIZE OF DRINKS Select serving quantity: 600 mL SELECT NUMBER OF DRINKS...
Then plug the unit back in and restart it. 600 mL HAMILTON BEACH COMMERCIAL Diagnostic Messages Service Messages Diagnostic Messages Others, such as service messages, are based on The ice shaver/blender control system has a number of safety and diagnostic features.
Troubleshooting Guide Problem . . . Solution . . . Unit will not run or • Check to see if unit is securely plugged into an electric outlet. stops while it is • Check to see if the fuse for the electric outlet has blown or if a circuit breaker running and cannot has tripped.
Page 12
Troubleshooting Guide – Status Messages Displayed Message. . . Solution . . . BLENDER MOTOR • Electric blender motor is too hot. This can be caused when the OVERHEAT—TURN OFF blender jar is too full or when blending very thick ingredients. Reduce MAIN POWER SWITCH the quantity of product in the jar and allow several minutes for the motor to cool before blending.
Page 13
Troubleshooting Guide – Status Messages Solution . . . Displayed Message. . . • The blender cutter assembly should be replaced whenever it is worn SERVICE MESSAGE or damaged, or when the unit displays the reminder “REPLACE REPLACE CUTTER ASSEMBLY”. CUTTER ASSEMBLY •...