Assembling Belt A N D Pulley Guard - KBC WS-18 Manual

3. Using the four bolts, flat washers
Consult your Dealer or Catalog for the
for use with vour saw.
and hex head nuts
recommended motor
4. Assemble motor pulley 11) Fig. D to the motor shaft.
Make sure the set screw in the motor pulley engages with key
in motor shaft. Using a straight edge, make sure the motor
pulley
(11
and driven pulley
12)
are in alignment. I f necessary,
both pulleys can be moved in or out. The motor can also be
moved if necessary.
5 .
Assemble the V-Belt
(3)
Flg.
E.
to the two pulleys and
adjust for proper belt tension by forwarding or backwarding
the motor. Keep pulleys in alignment when doing this.
Correct belt tension is obtained when there is approximately
1"
deflection in the center span of the pulleys with lighr finger
pressure.
ASSEMBLING BELT A N D PULLEY GUARD
Place the belt and pulley guard ( 1 ) ~ i g .
E,
on the surface of
base "shelf".
Use the three hex. head screws to fasten in
Place.