Subscribe to Our Youtube Channel
Summary of Contents for Draper 59319
- Page 1 PASSIVE INFRA RED (PIR) DETECTION ALARM WITH REMOTE CONTROL STOCK No.59319 PART No.AL8 • INSTRUCTIONS• IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY TO ENSURE THE SAFE AND EFFECTIVE USE OF THIS TOOL. 06/2000...
- Page 2 FEATURES Your passive infra red sensor alarm with keyring type remote control offers you the protection of professional alarm security that you can install yourself in minutes. It uses a passive infra red (PIR) motion sensor to detect intruders and activate a built-in alarm siren. To arm or disarm the sensor alarm, you simply press “ON”...
-
Page 3: Parts Identification
PARTS IDENTIFICATION 1. Motion sensor. 2. Infra-red Remote Receiver. 3. Low Battery Indicator. 4. Siren. 5. External AC Adaptor Socket. 6. External Siren Socket. 7. Battery Compartment. 8. ON (Alarm). 9 Infra-red Remote LED. 10. OFF (Alarm). 11. Battery Compartment. 12. -
Page 4: Installing Batteries
PREPARATION INSTALLING BATTERIES 1. Remove the screw at the base of the alarm unit and lift from the bottom of the back cover. 2. Place (4) AA alkaline batteries following the polarity symbols (+ and –) marked inside the battery compartment. -
Page 5: Setting The Security Code
PREPARATION Cont’d. SETTING THE SECURITY CODE A programmable 4-position security code switch is built- in the alarm unit and the remote control to prevent other transmitters or radio devices from sounding the unit. Each unit is factory preset. To change The Factory Preset Code On The Sensor Alarm Unit: 1. -
Page 6: Installation
INSTALLATION The sensor alarm is designed to be either mounted on a wall or free standing placed on a flat surface – desk, shelf, cabinet, etc. When selecting the location for the sensor alarm, keep in mind that the Passive Infra red Sensor is triggered by heat and motion. -
Page 7: Operation
OPERATION ARMING ALARM When leaving the protective area, point the remote control at the sensor alarm and press the ON (alarm) button. There will be a short beep, followed by a 30 second delay before the unit is armed. The exit delay allows you time to leave the protected area without activating the alarm. -
Page 8: Optional Accessories
OPTIONAL ACCESSORIES KEYCHAIN REMOTE CONTROLS Get one for every family member! The optional Keychain Remote Control provides every family member with access to the sensor alarm. AC ADAPTOR To prolong battery life,an optional AC Power Adaptor may be used to power the alarm.Simply plug it into the AC Adaptor Socket (see ‘Parts Identification’on Page 2),and feed the cable through the notch in the bottom of the back cover as the alarm unit is snapped into place. -
Page 9: Battery Precautions
CAUTION The alarm siren is very loud. For your safety, never place the unit close to your ears or let it sound for long lengths of time. BATTERY PRECAUTIONS • Use only new batteries of the required size and recommended type. •... - Page 10 NOTES - 9 -...
- Page 11 NOTES - 10 -...
- Page 12 © Published by Draper Tools Ltd. No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, mechanical photocopying, recording or otherwise without prior permission in writing from Draper Tools Ltd.
Need help?
Do you have a question about the 59319 and is the answer not in the manual?
Questions and answers