Summary of Contents for ICS Cutting Tools Electric Drill Bit Sharpener
-
Page 1: Instruction Manual
511 Main Street • P.O. Box 125 920-837-2526 Casco, WI 54205-0125 USA FAX 920-837-2530 Electric Drill Bit Sharpener INSTRUCTION MANUAL www.icscuttingtools.com • info@icscuttingtools.com... -
Page 2: Specifications
SPECIFICATIONS Power 0.58amps @ 120V, 60Hz; 1600RPM Working Capacity 9/64” to 25/64” (3.6mm to 10mm) SAVE THIS MANUAL. You will need the manual for the safety warnings and cautions, assembly instructions, operating procedures, maintenance procedures, troubleshooting, parts list, and diagram. SAFETY WARNING &... -
Page 3: Grounding Instructions
carefully checked to determine that it will operate properly and perform its intended function. Check for alignment and binding of moving parts; any broken parts or mounting fixtures; and any other condition that may affect proper operation. Any part that is damaged should be property repaired or replaced by a qualified technician. - Page 4 Rotate back OPERATIONS Center Point Cutting Edge and forth about 20° Trailing Edge Properly Sharpened Bits Your bit is properly sharpened when it has the following characteristics. See Figure 1. 1. A sharp point in the center of the bit. 2.
- Page 5 CLEANING 1. Make sure to keep the surface of your unit free of grit, dirt and grease. Use soapy water or nontoxic solvents. Do not use petroleum-based solvents. 2. Keep the air vents free of foreign matter at all times. TROUBLESHOOTING Sharpening Troubleshooting 1.
Need help?
Do you have a question about the Electric Drill Bit Sharpener and is the answer not in the manual?
Questions and answers