Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for ATEN GN0116
-
Page 1: Installation Guide
Installation Guide GN0116 Guardian Over the NET™ www.aten.com... -
Page 2: Installation Process
485 Input: In a daisy chained installation this is the chain in port of the child station. 232C: Used for a serial connection (either from a modem or a direct terminal connection from a local console) for monitoring, software updating, GN0116 Guardian Over the NET™ Installation Guide... - Page 3 MODEM port); as the demonstrator is using Turn on the GN0116's power switch. a notebook computer, an additional ATEN UC232A was used to convert the RS-232 signal to USB so it can be passed to the notebook computer through the USB interface.
-
Page 4: Software Installation
IP Setting Once the basic hardware installation is complete, an IP address must be acquired/set for the GN0116 to allow access. Insert the bundled software CD and install the GN0116 software on the computer. Software Installation The ATEN GN0116 offers three types of interface. -
Page 5: Sensors Installation
After logging in and completing the device configuration process (the GMC software will find all GN0116 devices on the same network segment), the notebook client can be used to view the status of all GN0116 ports. Guardian Monitor Center network diagram:... - Page 6 >Smoke Detector / Beeper / Reed Switch Apart from the bundled sensors, with the appropriate cabling the GN0116 can also support a wide variety of sensors available on the market. For this demonstration, three sensor/alert devices...
- Page 7 Stripping the clip-on sensor device. the EA2110 current detector and voltage detection using the EA2310. EA2110/EA2210/EA2310 Sensor Boxes Sensors are provided with a standard GN0116 package, otherwise, ATEN offers the following models: EA2110 1 x AC Current Sensor Place the power wire on the clip-on sensor device.
- Page 8 Connect the other end of the cable to the Terminal Block slot on the EA2110. Once the sensor has been secured, use an UTP cab le to connect the EA2210's RJ-45 port to the GN0116. Use the Port 31/32 voltage-type Analog Input Port when conn ecting to the GN0116.
-
Page 9: Configuration And Operation
Note: Connecting to the wrong port may damage your system. Humidity Sensor EA2310 – Voltage Detector The ATEN EA2310 Sensor Box is mainly used for voltage detection. It provides one inlet a nd one outlet port so installation is very simple. - Page 10 Phone: +44-1753-539-121 Fax: +44-1753-215-253 www.aten.co.uk E-mail: sales@aten.co.uk © Copyright 2009 ATEN International Co., Ltd. ® ATEN and the ATEN logo are trademarks of ATEN International Co., Ltd. All rights reserved. All other trademarks are the property of their respective owners.
Need help?
Do you have a question about the GN0116 and is the answer not in the manual?
Questions and answers