Standard Configuration - Viper 5900 Installation Manual

Hide thumbs Also See for 5900:

Table of Contents

Learn Routine will be exited if:

■ Door is closed.

■ Ignition is turned off.

■ Program switch is pressed too many times.

■ More than 15 seconds between steps.

transmitter configurations

The transmitter can be programmed with the standard or single button arm/disarm configurations by using the

Auto Learn functions in the Transmitter/Receiver Learn Routine.

standard configuration

A remote that uses the standard configuration operates similarly to many factory keyless entry remotes. A stan-

dard configuration transmitter allows arming, disarming, and Panic Mode activation with separate buttons. When

programmed for standard configuration, the transmitter buttons are assigned to the following functions:

.................................operates ...........................Arm/Lock,

.................................operates ...........................Disarm/Panic OFF

.................................operates ...........................Start

.................................operates ...........................Channel 2—trunk

and

................operate............................Timer Mode

and

................operate ..........................Short Run/Turbo

and

................operate............................Channel 4

and

................operate............................Channel 5

Panic ON/Panic OFF

release

timer

Table of Contents

Show Quick Links

Table of Contents