Safety Information 9. Do not defeat the safety purpose of the polarized or grounding - type plug. a polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong.
FCC Information FCC part 15.19 This device complies with Part 15 of the FCC Rules, Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC part 15.21 Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Contents Safety Information Package Content Internet Radio Quick start Guide What you need before you can use your Internet Radio ............ 3 Controls Overview (a) ...................... 4 Controls Overview (b) ..................... 5 Setup Wizard ........................6 Select a station through Podcasts ..................16 Get Access code ......................
Internet Radio Quick start Guide What you need before you can use your Internet Radio Thanks for your buying! Before use it, you need to know followings: LAN Setting: • Make sure the internet service is ready and the network setting is available for LAN (ADSL or Cable Modems is highly recommended).
Controls Overview (b) Control Internet mode Press to turn on/off Radio POWER MODE Press to convert among Internet, Music player, DAB and FM mode in turn. 1 - 10 Press and hold to store preset stations. Press to play the station has been stored. BACK Press to return to previous menu page.
Setup Wizard Step 1 - Power up 1. Connect to your Internet Radio adapter and ensure the power LED is lighting up. 2. In use, it can be switched on or off by pressing either STANDBY/ON at the back of unit or POWER .
Page 10
5. Press to your local ‘Wlan region’, and then press SELECT to confirm. 6. Press to your prefered ‘SSID’, press SELECT to confirm. Radio will save it in memory. Note: In some cases, radio may find more than one network. Press to your favorite one, press SELECTto confirm.
Page 11
Note: WEP/WPA pass codes are case-sensitive. If you make a mistake while entering your password, select ‘ ’ to delete a character. Note: a.> for , its full name is Backspace. b.> the method of select : while cursor point to ‘ ’, Press and you can select , then press...
Access wireless network 1. After successfully ‘setup wizard’, the display will show as below, and then press SELECT to enter ‘Internet radio’ mode, SELECT 2. While cursor point to < Station list >, press to confirm. After trying to connect to network, if it shows: Please follow: a.
Local stations Note: make sure your radio already successfully connected to network. 1. Press to < Station list >, and then press SELECT to confirm. 2. Press to < Local China >, and then press SELECT to confirm. Note: ‘Local China’...
Choosing a station Note: ensure your radio has already connected to network. 1. Press to < Station list >, and then press SELECT to confirm. 2. Press to < Stations >, and then press SELECT to confirm. 3. There are five options available for you to choose a station as above photo shown. ...
Page 15
GENRE’ enables you to choose radio stations according to their content, for example Classic Rock, Sport, News, etc. a. Press to < Genre >, press SELECT to confirm. b. Press to your selecting type of content, press SELECT to confirm. c.
Connecting to wired network Step 1 – Choose LAN Setting Note: a. make sure LAN cable connecting to LAN socket already. 1. Press MENU to goes into ‘Main Menu’, press SELECT to confirm. 2. Press to < System settings >, press SELECT to confirm. 3.
Page 17
Step3 – Access Network Continue above steps, few seconds later, and it will show: If this happens, please follow: a. Check your Router, see it working normally or not. b. Check your LAN cable, make sure it hasn’t damaged, c. See the port of cable which inserting to LAN socket is well.
Page 18
How to shift to wireless network Note: to make this order works, you can either do a ‘factory reset’, or follow below steps: 1. Refer to ‘choose LAN setting’, which you can find at page 13, and then press <...
Select a station through Podcasts 1. After your radio has successfully connected to network, press to < Podcasts >. 2. Press SELECT to confirm, and then press to your favorite option. 3. Press SELECT to confirm, and then step by step to your selecting program. Get Access code 1.
Add station to ‘My favourites’ 1. visit website: http://www.wifiradio-frontier.com 2. Click on the register link. 3. Create account login, you need an Access code to complete it, which refer to page 16. Note: want a member login? Therefore you need to remember your registered ‘Email address’ and ‘Password’.
Add station to ‘My Added Stations’ 1. Visit website: http://www.wifiradio-frontier.com 2. Login as a member (at previous page, you registered). 3. You will able to take advatage of various additional features and services offered by Frontier Internet Radio Portal. 4. How to play ‘My added stations’? Your need two steps: a.
Changing the Station Information It is possible to view the information that is displaying on the second line of the display when listening Internet program. To view more information, you can press INFO repeatedly. • Description of Station This is scrolling text information supplied by the Internet station. It may comprise information on music titles or details of the programme which is provided by the broadcaster.
Station Updates Occasionally, Radio will tell you that it is receiving an updated station list. It does this automatically and periodically, ensuring your Radio always has the latest station directory on-board. Music player Mode Note: To play this order, read appendix at first, which at following pages is highly recommending! A.
DAB Mode Press MODE repeatedly until < DAB radio > is showing up. For initial use, it will make a full scan and store stations list in memory. Note: or enter < Main menu >, and then press to < DAB >, press SELECT to confirm 2.
Manual Tune: 1. Repeatedly press BACK, and then press to < Manual tune >, press SELECT to confirm. 2. Press to step between the channels and press SELECT to select the current channel. Note: If there is a multiplex corresponding to this channel and frequency, then the display will show a tuning meter with the signal strength and the multiplex name after a few seconds.
DRC (Dynamic Range Control) value You can set the level of the compression of stations to eliminate the differences in dynamic range or sound level between radio stations. Note: Set DRC to off indicates no compression, set DRC to low indicates little compression, set DRC to high shows maximum compression.
FM Mode A. GENERAL OPERATION Press MODE repeatedly until < FM Radio > is showing up. For initial use, it will start at the beginning of the FM frequency range (87.50MHz). Otherwise, the last listened FM station will be selected. ...
Page 28
C. AUDIO SETTING FM mode, at any step by pressing BACK to enter it’s setting mode < Audio setting >, press to confirm. While cursor point to SELECT select ‘YES’ or ‘NO’, and then press to confirm. Press SELECT...
General Operation Return to Main Menu Press MENU, and then press to < Main menu >. Or, you can move back to radio’s top-line < Main menu >, at any time by pressing the BACK repeatedly. Adjust Volume level ...
Setting Station Presets This unit can store 10 Internet, 10 DAB and 10 FM station presets. To preset current station: 1. Press and hold one of PRESET buttons 1-10 on remote control, until will show: Selecting a Preset station To select a stored station: 1.
Sleep Function 1. It can be activated from < Main menu > < Sleep >, press SELECT to confirm. 2. Press to define the sleep period which between 0 – 60 minutes. 3. When your expected period is appeared, press SELECT to confirm. ...
System settings How to Network setup Note: Familiar this order will allows you: take it to another building where you want to use it. re-scan Routers, or to manually configure the network parameters. view MAC address and Wlan region ------------ View settings. ...
Press to < Auto update >, press SELECT to confirm. Press to < Update from Network >, press SELECT to confirm, it is done! Set hour format Press to < Set format >, press SELECT to confirm. 2. Press to your favourite format, press SELECT to confirm.
2. Press to ‘ON’, and then press SELECT to confirm, it is done! How to set Language 1. It can be activated from < Main menu > < System settings > < Language>, press SELECT to confirm. 2. Press to your selecting one, and then press SELECT to confirm, it is done!
How to Factory reset Note: running this will completely erase your radio’s memory, preset stations, all WEP/WPA codes and other user settings. It can be activated from < Main menu > < System settings > < Factory reset >. 2.
How to Software Updates It can be activated from < Main menu > < System settings > < Software update >, press SELECT to confirm. 2. While cursor point to < Auto- check setting >, press SELECT to confirm, and then press <...
How to enter Setup wizard It can be activated from < Main menu > < System settings > < Setup wizard >, press SELECT to confirm. 2. Then step by step to set it. How to view SW Version and Radio ID 1.
Appendix Step 1: Set Up Media Sharing in WMP 11 After you download and install Windows Media Player 11 for Windows XP and connect your Radio to the network, you need to set up media sharing so that you can share music with your Radio. The following steps describe how to set up media sharing in Windows Media Player 11.
3. Check the “share my media to” box. In the list, click your Radio *, click Allow, the selected device will show a green tick and then click OK. If your device does not appear in the list of devices, perform the following steps; a.
Set Up Media Sharing in MAC OS Using the Radio with a MAC will require Windows File Sharing. MAC OS 9 and earlier versions of the OS will need extra software to use Windows File Sharing, but MAC OS X 10.2 and later versions have Windows File Sharing built into the OS.
Troubleshooting If you experience any trouble with your wireless Internet Radio, then you may find it useful to visit the help section on our webpage: http://www.wifiRadio-frontier.com If you have trouble connecting the Radio to your wireless network, these steps may help to resolve the problem: 1.
There are separate collection systems for recycling in the EU. For more information, please contact the local authority or your retailer where you purchased the product. International Receiver Company +45 7026 2446 www.ircgo.com...
Need help?
Do you have a question about the ADP1217WIFID and is the answer not in the manual?
Questions and answers