Page 1
About My Go-Ped® Model _______________________ Serial # _______________________ Motor _______________________ Motor Serial # _______________________ Gas:Oil Ratio _______________________ Dealer Service Center _______________________ Notes...
Page 2
-THERE ARE NO OTHER EXPRESS WARRANTIES. child, or to third parties to whom the child entrusts the vehicle. ______ Homeowners Insurance may not cover either Direct or Third Party Liability Claims Arising from Use of this or any other Go-Ped® product.
As a new Go-Ped® owner and User, you now have access to the widest dealer network, thousands of parts for your Go-Ped®, complete warranty coverage and instant access to service.
Page 4
The sprockets may be aligned by • You should check with a reliable authority in your state to see if the Go-Ped® must be registered as adding or removing washers between the rear wheel and the frame.
Here is a simple procedure you should get in the habit of before you get on your scooter: 3) Apply approx. 75 lb of weight to rear part of Go-Ped® deck (one knee on the “D” works pretty good) with rear wheel on the ground. (To apply proper tire/spindle contact).
E. Engine: Check the idle speed. Your Go-Ped® will go about 2 to 3 miles per hour at idle with the drive engaged. Make sure that the air filter is clean and clean if necessary.
Page 7
2.4) Rules to Scoot By: · Always wear your safety gear There are a few things you can do to keep your Go-Ped® engine at its best performance and · Never ride under the influence of alcohol or drugs cleanest for the environment.
7. Check for smooth wheel rotation and proper front brake actuation. before riding it hard. Control cables will stretch or “seat” when a new Go-Ped® is used for the first time and may require readjustment by your authorized Go-Ped® dealer. Your “Mechanical Safety B.
Go-Ped® dealer. Just as important is that your individual maintenance requirements will be determined by everything from your riding style to geographic location. Consult your authorized Go-Ped® dealer for help with determining your individual maintenance requirements.
Section 5: Controls Section 4: Oil & Fuel Information Your Go-Ped® has a two-stroke engine that requires two-cycle oil to be mixed with gasoline. Use CAUTION: Before you ride - Familiarize yourself with how your Go-Ped® works. a high quality 2 cycle oil that is formulated for small air cooled engines.