Table of Contents
Advertisement
PICTURE ADJ. (Picture adjustment): See page 16.
CONTRAST
BRIGHT
CHROMA*
1
PHASE*
2
SHARPNESS
sub menu
reset
SIZE/POSITION ADJ. : See page 17.
H SIZE
H POSITION
V SIZE
V POSITION
DOT CLOCK*
3
CLOCK PHASE*
3
sub menu
reset
FUNCTION SELECT: See pages 19 to 23.
COLOR TEMP.
ASPECT*
4
SIGNAL MODE*
5
RGB/COMPO.*
6
SYNC TERM.*
7
reset
STATUS DISPLAY: See page 24.
Shows the input mode and signal type on the screen.
1
*
Adjustable when viewing the NTSC, PAL or SECAM signal, or component signal.
*
2
Adjustable when viewing the NTSC signal or component signal.
3
*
Adjustable when RGB A or RGB B input is selected.
*
4
Not adjustable when viewing the following component signals—720/60p, 1080/60i (1035/60i), and 1080/50i. ( In such a case,
"ASPECT" does not appear on the display.)
*
5
Adjustable when VIDEO A, VIDEO B, or COMPONENT input is selected.
*
6
Adjustable when RGB B or COMPONENT input is selected.
7
*
Adjustable when RGB B input is selected.
Adjusts the contrast of the picture.
Adjusts the brightness of the picture.
Adjusts the color density of the picture.
Adjusts the color phase.
Adjusts the outlines of the picture.
Displays the fine adjustment bar.
Resets the Picture Adjustment Menu settings to defaults.
Adjusts the horizontal screen size.
Adjusts the horizontal screen position.
Adjusts the vertical screen size.
Adjusts the vertical screen position.
Adjusts to eliminate stripes or flickering. Use with "CLOCK PHASE."
Normally, no adjustment is needed.
Adjusts to eliminate stripes or flickering. Use with "DOT CLOCK."
Normally, no adjustment is needed.
Displays the fine adjustment bar.
Resets Size/position Adjustment Menu settings to defaults.
Adjusts the color temperature.
Use when the picture is reddish or bluish.
Selects the horizontal to vertical ratio of the screen.
• Selects a color system (NTSC, PAL, SECAM, NTSC 4.43, PAL60) when VIDEO A or VIDEO B
input is selected. Normally, set to "AUTO."
• Selects a scan system—480i, 576i, 480p, 576p, 720p, 1080/60i (1035i), 1080/50i—when
COMPONENT input is selected. Normally, set to "AUTO."
Selects the usage of the COMPONENT/RGB B terminals either as the COMPONENT input
terminal or as the RGB B input terminal.
Adjusts the resistance of RGB B input terminals.
Resets the Function Selection Menu settings to defaults.
35
Advertisement
Table of Contents
