Do you have a question about the AA83-001 and is the answer not in the manual?
Questions and answers
Summary of Contents for Anodyne Electronics Manufacturing AA83-001
Page 1
SPECIAL NOTICE This product is now licensed to Anodyne Electronics Manufacturing (AEM) from Northern Airborne Technology (NAT). AEM is responsible for all matters related to this product, including sales, support and repair services. Please note the transition to convert product manuals and supporting documentation is an ongoing process and is being addressed on an ‘as needed’...
Page 4
AEM MANUAL REVISIONS Section Revision Number Revision Description Issue Date Rev 5.00 Updated template and drawings April 17, 2012 Page iii Installation and Operation Manual ENG-FORM: 820-0100.DOTX CONFIDENTIAL AND PROPRIETARY TO ANODYNE ELECTRONICS MANUFACTURING CORP.
(direct connection to the aircraft radio system) are standard features on all AEM intercom systems. The AA83-001 can support PTT ICS operation for all users, and can be wired to cyclic/yoke switches for both TX and ICS functions.
TX, active ICS, and incoming Receive Audio all mute the music channel (Muting depth adjustable) Fast attack, slow return of music signal Pilot TX priority April 17, 2012 Rev: 5.00 Page 1-2 ENG-FORM: 800-0100.DOTX CONFIDENTIAL AND PROPRIETARY TO ANODYNE ELECTRONICS MANUFACTURING CORP.
Verify that all items are present before proceeding and report any shortage immediately to your supplier. 2.2.1 Warranty All Anodyne Electronics Manufacturing Corp. (AEM) products are warranted for 2 years. See the website www.aem-corp.com/warranty for complete details. Installation Procedures 2.3.1 Warnings Do not bundle any lines from this unit with transmitter coax lines.
All AA95/AMS4X Audio Controllers used with the AA83-001 must have the ICS Tie Line and Gain Modifications installed. This will only be a concern on Audio Controllers with S/N 1918 or before. If the AA83-001 is used with a second unit such as an AA82, you may wish to install the 2.2 k resistor shown in the installation drawing.
2.3.6 Setting Music Input Compatibility The AA83-001 (S/N 1091and up) can be configured to be Low-Z or High-Z circuits by two internal jumpers (J103 and J104), which can be accessed by removing the cover and top PCB from the AA83- 001.
AA83-001 InterMUSIC™ Stereo Intercom System SM09-2 Installation and Operation Manual To gain access to the jumpers, remove the cover from the AA83-001. Remove the top PCB by removing three pan-head screws and carefully lifting it straight up. When reassembling the unit ensure the pins and connector are aligned properly before screwing the PCB down.
NEVER USE MONO AIRCRAFT HEADSETS in the system, as they will short out one side of the AA83-001 power amplifier when installed in stereo jacks. This may result in eventual unit failure, which IS NOT COVERED BY WARRANTY.
SM09-2 Installation and Operation Manual Continued Airworthiness Maintenance of the AA83-001 is ‘on condition’ only. Periodic maintenance of this product is not required. Accessories Required Installation kit p/n AA83-IKC is required to complete the installation. The kit consists of the following:...
ICS and radio monitor operation for two additional passengers. Pilot priority on transmit and pilot isolation (direct connection to the aircraft radio system) are standard features on all AEM intercom systems. The AA83-001 can support PTT ICS operation for all users, and can be wired to cyclic/yoke switches for both TX and ICS functions.
The green LED also indicates a possible stuck mic if still lit after transmission is concluded. April 17, 2012 Rev: 5.00 Page 3-2 ENG-FORM: 806-0100.DOTX CONFIDENTIAL AND PROPRIETARY TO ANODYNE ELECTRONICS MANUFACTURING CORP.
3.3.5.1 Normal Mode In normal use, the AA83-001 serves as a common intercommunication system for up to four users, and a flow-through interface for connection to the ship's external communication system. The front panel controls allow both the pilot and copilot (plus the passengers) to set their respective VOX trigger points independently to match different headsets or noise locations.
This can be used for common communication from front to rear (for example) in a larger aircraft. When set to the SPLIT position, the AA83-001 cuts the tie line, breaking the two units into individual intercom circuits with isolated conversations. In this way, many different circuit combinations can be set up, depending on what device is hooked to the tie line.
Active Idle Idle Idle Muted Idle Active Idle Idle Muted Muted Idle Active Muted Muted Muted Idle Idle Active End of Section 3.0 April 17, 2012 Rev: 5.00 Page 3-5 ENG-FORM: 806-0100.DOTX CONFIDENTIAL AND PROPRIETARY TO ANODYNE ELECTRONICS MANUFACTURING CORP.
Need help?
Do you have a question about the AA83-001 and is the answer not in the manual?
Questions and answers