Maintenance; Troubleshooting Guide - Germ Guardian H2000 Use & Care Instructions Manual

H2000REV0608:Ultrasonic Humidifier Manual 2L

MAINTENANCE

· Always unplug the unit before servicing it in any way.
· The water temperature of the water remaining in the unit after use may be high.
· Do not submerse the unit in water, or allow water to enter the inside of the unit.
INSIDE THE BODY OF THE UNIT
Pour excess water out of the unit, but do not allow it to enter the blast port. Wash out the
unit with fresh water, using the cleaning brush and a soft cloth as needed.
OUTER SURFACE OF THE UNIT
Wipe the surface of the unit with a soft damp cloth if needed.
WATER TANK
If water spots remain in the water tank, wipe the inside down with a soft cloth. Do not use
soap or detergents.
AIR FILTER
Gently wipe away debris from the filter with a soft cloth.
ULTRASONIC DISK
Remove spray spout (Fig. 1) and use the enclosed cleaning brush to regularly remove build up
and deposits from this area (Fig. 2). White vinegar will help to prevent this build up.
Fig. 1 Fig. 2
· Fully dry the inside and outside of the unit before storing it.
· DO NOT leave water in the unit.
· Store in a cool dry place.
E-6
6/16/08 1:41 PM Page 4
STORAGE

TROUBLESHOOTING GUIDE

PROBLEM SOLUTION
Water vapor & humidity are not Power Plug: Unplug and then try again.
produced.
Power Failure: When the power is returned, try again.
Bucket Installation: Make sure the bucket is correctly
attached.
Air blows but water vapor is Excessive Water: Remove a certain amount of water from
not produced. the bucket.
The desired humidity is lower than the current
temperature: increase the desired humidity.
Detergent residue in the bucket: Wash the bucket out
and try again.
Humidity level is low. The surface of the vibrator is dirty: clean the vibrator.
The water in the unit is too cold: Replace with cool, but
not cold water.
Damage on the vibrator: Exchange the vibrator.
Warm humidity is not produced. It may take 10-15 min. before warm humidity is created.
The humidity has a bad smell. Poor maintenance or dirty water: Clean the product
thoroughly, and fill it with fresh water.
White dust is forming on nearby Hard water may deposit a certain amount of dust. Dust in
furniture. the air also settles because of added humidity in the room.
Use distilled water if this becomes a nuisance.
E-7