Table of Contents
Advertisement
2.
Connect the Vernier Voltage Probe to Ch.1 of SensorDAQ. Attach the leads to a
9V battery.
3.
Click the run arrow
sensor and adjust the graph and axes labels accordingly.
4.
Allow the data collection to complete after 18 seconds, or you may stop it early
by clicking the STOP button.
In this example, Ch.1 is used and the sample rate, samples to be read, and collection
time are all defaults read from the auto-ID sensor. In this example, these defaults
cannot be adjusted. Additional example VIs are available that allow you to adjust the
Data Collection with one vernier analog sensor
to begin data collection. LabVIEW will identify the
SensorDAQ User's Manual
9
Advertisement
Table of Contents
