Table of Contents
Advertisement
Quick Links
LEAVE THIS DOCUMENT WITH THE HOUSEHOLDER!
All Portway Stoves exceed the safety and performance requirements of European Standards
Intermittent burning solid fuel roomheaters for installation with a single dedicated chimney.
Fuel
Test Standard
Test Cycle
Settings
Flue Draught Pa (ins WG)
Efficiency %
Recommended Output Rating kW
Output when fitted with reducer
brick pair, kW
Mean Flue Gas Temp Rise ºC
Minimum air entry requirement
Minimum Clearance to
combustibles (allow min 50mm
clearance to non-combustibles)
NOx mg/m³
CO %
CxHy mg/m³
Gas flow g/sec
Smoke Emission mg/m³
Read these instructions! Use only recommended fuels!
This document, when completed by the installer, constitutes part of a 'Hearth Notice' for purposes of Building
Law. It must be left with the householder and placed where it can easily be found.
INSTALLED AT LOCATION:
BY:
EMERGENCY CONTACT:
I definitively assert that this installation is safe, has been lit and demonstrated to the householder,
conforms with current building regulations and with these instructions
SIGNED:
PRODUCTION NUMBER
INSTALLATION AND OPERATING INSTRUCTIONS
Independently tested by SGS Environmental Laboratory BV, Arnhem
Portway No1
Mineral Fuel
Wood (Beech)
(Anthracite)
1.15kg over
0.76kg over
0.75hrs
1.1hrs
Primary 0,
Primary 30,
2nd 25mm
2nd 25mm
12 (0.05)
12 (0.05)
78.8
78.2
4.9
4.9
3.0
3.0
226
216
2700 mm ²
350mm
With 150mm or longer legs or base fitted, hearth temperature is <100°C – A light duty hearth
44
-
0.19
0.10
169
-
4.6
5.4
38
21
Portway No2
Wood
Mineral Fuel
(Beech)
(Anthracite)
EN 13240:2001+A2 2004
1.51kg over
1.05kg over
0.72hrs
1.0hrs
Primary 0,
Primary 35,
2nd 25mm
2nd 20mm
12 (0.05)
12 (0.05)
78.2
77.3
6.9
6.9
5.0
5.0
280
292
3800 mm ²
300mm
may be used.
77
-
0.14
0.08
94
-
5.4
6.1
74
36
DATE:
TO FIND A QUALIFIED INSTALLER, FUEL SUPPLIER or CHIMNEY
UK: The Solid Fuel Association, 7 Swanwick Court, Alfreton, Derbyshire DE55
7AS Tel:0845-601-4406 www.solidfuel.co.uk
RoI: Irish Nationwide Fireplace Organisation, 162 Capel Street, Dublin 1
Tel:01-801-5959 www.fireplace.ie
Portway 1, 2, 3 and Inset stoves may be used in smoke control areas
when operated strictly in accordance with these instructions and with
Soliftec Smoke Advice Sheet No1
(www.soliftec.com/smokeadvice.htm), when burning:
UK: Untreated wood logs or authorised smokeless fuels (Exempted from s20
of the Clean Air Act 1993)
RoI: Wood logs, smokeless fuels or peat briquettes, but not petroleum coke
(Control of Atmospheric Pollution Regulations, 1970)
1
Solid Fuel Stoves Manual v4. Issued - 11/03/2014 (382)
SOLID FUEL
HEATING STOVES
MULTI-FUEL MODELS
Portway No3
Wood
Mineral Fuel
Wood (Beech)
(Beech)
(Anthracite)
2.15kg over
1.65kg over
1.06kg over
0.73hrs
1.01 hrs
Primary 0,
Primary 45,
2nd 25mm
2nd 25mm
12 (0.05)
12 (0.05)
76.3
70.0
9
9
7.1
7.1
297
358
4900 mm ²
300mm
In masonry fireplace, 150mm
55
-
0.19
0.08
205
-
7.3
10.0
135
21
Flue Draught measured
on commissioning:
commissioning
SWEEP, CONTACT:
Portway Inset
Mineral Fuel
(Anthracite)
EN13229: 2001
0.74kg over
0.82hrs
1.01 hrs
Primary 5,
Primary 32,
2nd 30mm
2nd 20mm
12 (0.05)
12 (0.05)
76.5
75.5
4.7
4.7
2.9
2.9
237
273
2700 mm ²
at sides
350mm above
66
-
0.35
0.08
761
-
4.6
5.0
78
14
Pa
WG
Fuel used on
Advertisement
Table of Contents
Summary of Contents for Portway Stoves Portway No1
-
Page 1: Solid Fuel
All Portway Stoves exceed the safety and performance requirements of European Standards Intermittent burning solid fuel roomheaters for installation with a single dedicated chimney. Independently tested by SGS Environmental Laboratory BV, Arnhem Portway No1 Portway No2 Portway No3 Portway Inset... - Page 2 IN 1830 Charles Portway built a stove to heat his ironmongery shop at Halstead in Essex. It was so good that his neighbours started asking for them. Mr Portway had done something completely new - designed his stoves right from the start to give out the maximum heat from the minimum fuel, so that he is known as "The Founding Father of Energy Efficiency".
- Page 3 and ash, remove the throat plate and leave all the air controls open to CHECK THE INSTALLATION ! allow ventilation to reduce condensation. Once installed, light the fire, demonstrate it to the householder and FUELS check that: It burns controllably and does not emit fumes to the room There is no 'perfect' fuel, so we strongly recommend that you try a The route for gases from the stove to the chimney terminal is selection of fuels (or mixtures) to find which suits you best.
- Page 4 excessively until the gases in them have been used up. You can certain wind conditions (often incorrectly ascribed to 'downdraught', reduce this effect by making sure that the fire is set to 'low' for a while which is in fact very rare), where air can be sucked out of the room. before refuelling and checking that the door seals fully.
Need help?
Do you have a question about the Portway No1 and is the answer not in the manual?
Questions and answers