Table of Contents
Advertisement
The tour interface is shown as in Figure 7-86. Here you can set tour interval, split mode, motion
detect tour and alarm tour mode.
Please refer to the following sheet for detailed information.
Parameter
Enable tour
Interval
Split
Motion
tour/Alarm
tour
7.8.5.3.4
Video Matrix
The video matrix interface is shown as in Figure 7-87.
Here you can set video matrix output channel and interval. It supports 1/4/9/16 spot tour.
Note:
HD-SDI series product does not support this function,
960H series only supports single-window spot tour.
Figure 7-86
Function
Check the box here to enable tour function.
Here is for you to adjust transparency. The value ranges from 5 to
120s. The default setup is 5s.
Here you can set window mode and channel group. System can
support 1/4/8/9/16/25/36-window according to device channel
amount.
Here you can set motion detect tour/alarm tour window mode.
System supports 1/8-window now.
307
Advertisement
Table of Contents
