Table of Contents
Advertisement
If you have two or more computers (desktops or laptops) and want to share files, printers, and
Internet access using one computer or laptop as an Internet Server, then follow the instructions
below. When you have completed your network, it should look similar to this:
To share an Internet connection with Internet Sharing software you will need to purchase Internet
Sharing software or use the Internet Connection
Sharing (ICS) utility provided with Windows XP, Windows 2000, Windows ME or Windows 98SE.
Please follow your software documentation to properly configure the Internet sharing software
after you install your wireless networking cards. To install your wireless network card follow the
instructions on the next page.
If the Internet Sharing Software will be installed on the same computer into which you are
installing this wireless network card, then follow these steps:
Install the 108Mbps 11G+ Wireless PCI Adapter.
1.
Check the Device Manager to confirm that your card is installed correctly.
2.
Install your Internet Sharing Software
3.
4. If required by the ICS software, set the static IP Address for the wireless card.
Note:
The IP Address for all computers must be in the same IP Address range, and the Subnet Mask must be the
same for all computers on your network. For example: If the first computer is assigned an IP Address of
192.168.0.2 with a Subnet Mask of 255.255.255.0, then the second computer can be assigned an IP Address
of 192.168.0.x (where x is a number between 3 and 254) with a Subnet Mask of 255.255.255.0, etc.
IEEE 802.11g PCI Card Wireless Network Adapter
11
Advertisement
Table of Contents
