Positioning Belt; To Install The Positioning Belt (If Required); To Adjust The Positioning Belt For Operator Comfort; To Release The Positioning Belt - Pride Mobility Go Go ES Owner's Manual

V I . C O M F O R T A D J U S T M E N T S
6. Raise or lower the upper seat post to the desired seat
height.
7. While holding the upper seat post at that height, align the
adjustment holes of the upper and lower seat posts.
8. Fully insert the detent pin.
9. Replace the battery pack and connect the battery
harnesses.
10. Fasten the battery tie-down strap.
11. Reinstall the rear shroud.
12. Reinstall the seat.
POSITIONING BELT (OPTIONAL)
Your scooter seat may be equipped with an auto-type
positioning belt that can be adjusted for operator comfort.
See figure 19. The positioning belt is designed to help
support the operator so that he/she does not slide down or
forward in the seat. The positioning belt is not designed for
use as a restraining device.
WARNING! The positioning belt should be
secured at all times. Never allow the
positioning belt to hang or drag on the floor
as it may become entangled.

To install the positioning belt (if required):

1. Remove the seat from your scooter.
2. Place the seat upside down so that you can see the bottom
of the seat base.
3. Remove the two bolts on the outermost part of the rear
seat mounting strap. See figure 20.
4. Insert the bolt through the appropriate end of the
positioning belt and then through the seat mounting strap
for each side of the scooter seat.
5. Tighten the bolts.

To adjust the positioning belt for operator comfort:

1. Insert the metal tab on the right side of the belt into the plastic housing on the opposite strap until you
hear a "click."
2. Pull the strap on the right side of the belt until it is secure, but not so tight as to cause discomfort.

To release the positioning belt:

1. Press the push button mechanism on the plastic housing.
MANDATORY! Make sure the positioning belt is properly secured to the scooter and is
adjusted for operator comfort.
MANDATORY! Inspect the positioning belt for loose or damaged parts before each use of
the scooter. If you discover a problem, contact your authorized Pride Provider for
maintenance and repair.
32
www.pridemobility.com
Figure 19. Positioning Belt
POSITIONING BELT BOLTS
Figure 20. Positioning Belt Bolts
Go-Go ES