Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Peak Performance PKC0RE
- Page 1 Back-Up Sensor System Model No.: PKC0RE Owner’s Manual and Warranty Information POWER 0.4m/1.3ft 0.6m/2.0ft 1.0m/3.3ft 1.2m/4.0ft 1.5m/5.0ft RIGHT LEFT Read these instructions completely before using this product. Retain this Owner’s Manual for future reference.
- Page 2 FEATURES Detects objects or people from approximately 5 ft (1.5 m) away • Indicates the clearance between the vehicle and the object through audible alarm and red, yellow or • green LED indicator lights Adjustable alarm volume • Two rear sensors for optimum object detection •...
-
Page 3: Installation
INSTALLATION Some states or local governments may have regulations or laws that restrict the use of anything that might impair the clear view of a license plate. Check local laws for compliance. For the Back-Up Sensor to be properly installed, it must be wired into the vehicle’s taillight harness. - Page 4 Determine which are the positive (+) and negative (-) wires for the reverse lights on the vehicle. You can use either the right- or left-side reverse light wires. For help locating the vehicle’s reverse light circuit, contact your vehicle’s manufacturer for vehicle-specific wiring diagrams. Remove the vehicle’s negative (-) battery cable.
-
Page 5: Operation
Using a small piece of wire or paper clip, push the learn link button on the back of the receiver. When a mutual frequency has been found, the receiver will beep twice. If a mutual frequency was not found, the red LEDs next to the “0.4m/1.3ft” on the receiver will flash, but the receiver will not beep. -
Page 6: Specifications
SPECIFICATIONS DC Input Voltage 10-16V Controller Operation Current ≤ 75mA Receiver Operation Current ≤ 75mA Receiver Unobstructed Range ≥ 49 ft (15 m) Alarm Volume at 11.8 in. (30 cm) Away ≥ 50dB Frequency 433.92 ± 0.2Mhz Working Temperature 14°F to 113°F (-10°C to 45°C) FCC INFORMATION Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. - Page 7 TROUBLESHOOTING - continued Problem Situation Action Receiver and/or Sensor system wires are loose or improperly Ensure all wires are correctly controller power connected connected to the receiver, LEDs do not controller, sensors and into the illuminate when the vehicle reverse light circuit. vehicle is put into Check all wire connections and reverse...
Need help?
Do you have a question about the PKC0RE and is the answer not in the manual?
Questions and answers