Sarabec LA215 User Manual

Sarabec LA215 User Manual

Loop system

Advertisement

Sarabec LA215 User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LA215 and is the answer not in the manual?

Questions and answers

Summary of Contents for Sarabec LA215

  • Page 1 Connevans S S o o l l u u t t i i o o n n s s t t o o i i m m p p r r o o v v e e t t h h e e q q u u a a l l i i t t y y o o f f l l i i f f e e This product may be purchased from Connevans Limited secure online store at www.DeafEquipment.co.uk DeafEquipment.co.uk...
  • Page 2: Specifications

    • Blue Light Emitting Diode (LED) for Power On indication. Functions • Red Light Emitting Diode (LED) Loop Level Indicator Sarabec Ltd declares that the LA215 complies with the relevant EU directives. The full declaration of conformance for the LA215 is available from Sarabec Ltd.
  • Page 3: Quick Setup

    OPERATING INSTRUCTIONS INTRODUCTION The Sarabec LA215 Loop System provides a practical solution for hearing aid users to listen more easily to their TV or Audio equipment via Quick Setup the “T” or “MT” facility of their hearing aid. With no direct connection between the user and the TV the user is able to move freely within the looped area and listen comfortably to the TV or other equipment without the distractions of normal listening.
  • Page 4: Safety Precautions

    If you need to change the mains plug supplied, the colours of the wires in the mains lead of this apparatus may not correspond with the coloured Sarabec ltd markings identifying the terminals in your plug. Proceed as follows: The...
  • Page 5 Loop Cable SETTING UP • Run the loop cable around the room starting and ending at the amplifier, figure (A). The A loop system is supplied ready for use with the following items cable may be tucked under the edge of the •...
  • Page 6: Direct Connections

    Direct connections OPERATION The preferred method to connect the loop amplifier to your TV or other sound system is to use the line Before switching on, ensure that the Volume control (1) is set to minimum input of the Loop Amplifier. This uses the red/white and the Tone control (2) is set in the normal position (12 ‘o’...
  • Page 7 FUNCTION BUTTONS PROBLEM’S AND CURES All the function buttons are operated in the same way. Press the button to turn on, the Symptom Possible cause and remedy associated led will light. Press the button No sound. • Re-check all connections. again to turn off and the led will go out.

Table of Contents