Removing The Outer Casing - HouseWarmer HW250GW0XX1(N,P)-1 Installation Instructions And Owner's Manual

When optional blower is not installed. At the top of the
1.
outer casing, remove one (1) screw from the center clearance
slot that attaches the outer casing to the header assembly.
When optional blower is installed.
screws that attach blower front to blower housing. Separate
blower front from blower housing. Remove blower front
by disconnecting fan control switch wire assembly from
power cord and motor wire. Remove two (2) screws from
the outside clearance slots that attach the outer casing to the
header assembly.
23800-5-0909

REMOVING THE OUTER CASING

Figure 27
Remove four (4)
Figure 28
2. Open casing door. Remove two (2) screws that attach bottom
of outer casing to inner casing.
3. Remove outer casing from unit and place aside.
Figure 29
Figure 30
Page 15