Using The Wps Button (Only Sf1301W) - Avermedia AVerDiGi SF1301 User Manual

1.6.3

Using the WPS Button (Only SF1301W)

Wi-Fi Protected Setup (WPS) is a standard for easy and secure establishment of a wireless home network.
The wireless camera and AP (Access Point) device must both support WPS.
Please refer the following steps to enable WPS function:
1. Please make sure your Access Point (AP) device supports WPS function.
2. Pressing the WPS button of AP.
3. Press and hold the WPS button of IP camera until the power LED turns off (about 5 seconds), and then,
the LED will start to blink at every 2 seconds that means WPS function is set.
4. And then, wait about 120 seconds for WPS to be functional between AP and the IP camera.
5. According the power indicator can indicates the following status:
Enable WPS Successful: power LED is lighting and IP camera will reboot automatically.
Enable WPS Fail: power LED is blinking every 10 seconds until 120 seconds later, and then IP camera
will reboot automatically.
6. If WPS setup is failed, please re-do the above steps 2 to 4.
6