ReadyNet HD network Adapter User Manual

Overview
The Adapter uses 128-bit AES encryption to block access from the out-
side. By default, the protection is enabled. However, it is recommended
that you change the default network password with the "Encryption"
button located (next to the Ethernet port) on the units.
Changing the Network Password
1. With both Adapters plugged into the wall, press the "Encryption"
button on both units for 10 seconds. The password on these
Adapters has now been changed to a random value.
2. Next, press the "Encryption" button on one unit for more than 0.5
seconds, but less than three seconds.
3. Within two minutes, press the "Encryption" button on the second
unit for more than 0.5 seconds, but less than three seconds.
4. The new network password has now been saved to the second
unit. The password will not be lost, even if the Adapters are
unplugged from the wall.
Adding Another Adapter to the Network
1. If the default network password has been changed, a new Adapter
will have to load the new password before it can join the network.
2. Press the "Encryption" button on an encrypted unit for more than
0.5 seconds, but less than three seconds.
3. Within two minutes, press the "Encryption" button on the new unit
for more than 0.5 seconds, but less than three seconds.
4. The new device has now been loaded with the network password
and added to the current powerline network.
Resetting to Factory Defaults
Using a pointed object, press and hold the "Reset" button for two
seconds to restore defaults. This procedure resets the network
password to the default out-of-box value.
Website: www.readynetsolutions.com
Customer Service: 855.671.7932
HD network Adapter
High Speed Data/Video Streaming

USER MANUAL