Camera Types - BBV TX1500 system Installation Manual

CAMERA TYPES

These screens are used to set the type of telemetry for each camera and which monitors and keyboards are allowed to
view and control each camera.
Camera Setup Selection
Cameras 01 - 08
Cameras 09 - 16
Cameras 17 - 24
Cameras 25 - 32
Cameras 33 - 40
Cameras 41 - 48
Cameras 49 - 56
Cameras 57 - 96
Return
Start at Cameras 01 – 08 to display the setup screen
Camera 01-08 Kbd
1234 12345678
01 BBV coax YYYY YYYYYYYY
02 BBV coax YYYY YYYYYYYY
03 Static YYYY YNYYYYYY
04 BBV coax YYYY YYYYYYYY
05 BBV 422 YNNN NYNNNNNN
06 BBV coax YYYY YYYYYYYY
07 Unused YYYY YYYYYYYY
08 Unused YYYY YYYYYYYY
Return Menu
The choices for camera type are:
BBV coax - Standard BBV up-the-coax telemetry (Rx100/200/300/400P/400DC/Rx45X & Rx55X)
BBV 422 - BBV RS422 telemetry also used when driving additional protocols via a StarCard/converter
VCL coax - Control only available on monitors 1-4 this is a limited implementation of the Protocol
PEL coax - Control only available on monitors 1-4 this is a limited implementation of the Protocol
VISTA cx - Supports VISTA POWER DOME and other Domes VISTA range.
Contact support for more information
VISTA TP - Supports VISTA POWER DOME and other Domes VISTA range.
Contact support for more information
STATIC - Telemetry is disabled
Unused – The camera is not fitted and can't be viewed manually or in a sequence.
Other types may be selectable, please check with BBV before choosing these.
BBV coax would be used to control the existing range of BBV up-the-coax receivers.
Rx100 for dome control. Rx200/300/400P for AC heads, Rx400DC for high/variable speed 24Vdc heads.
The maximum distances that should be used are: 250M of RG59 and 500M of CT125 grade cable.
BBV 422 is used to drive the new advanced range of addressable BBV receivers that are controlled using two wire
RS422. The RX45X is used when driving AC pan/tilt heads and the RX55X is used for high/variable speed 24Vdc
heads. Both receivers offer additional features including an On Screen Display with an advanced menu system, 8 local
alarm inputs, wide input supply, DIP switch addressable allowing either star or daisy chained wiring.
rd
Selected 3 party domes and telemetry receivers can be controlled via RS422 and a BBV STARCARD/CONVERTER.
The camera type must also be set to BBV 422.
Full details can be found on the BBV web site
Kbd: If a keyboard is allowed to control the camera, select Y, or if the keyboard can only view but not control the
camera, select N.
Monitor: Select Y if the camera can be displayed on each monitor or N if not. This allows cameras to be hidden from
specific monitors/operators.
TX1500 Manual V3.5 Dec 07
The cameras are again displayed in banks of 8 as shown on the
following screen:
This example shows Camera 1,2,4 & 6 with coax telemetry and able to
be viewed on all monitors and controlled from all keyboards.
Monitor
Camera 3 is a static camera that can be viewed on all monitors apart
from monitor 2.
Camera 5 is driving via BBV RS422 and can only be viewed on monitor
2 and controlled by keyboard 1.
Cameras 7 & 8 are unused.
Next8
www.bbvcctv.com
Page 20 of 40 MATRIX PROGRAMMING/USER GUIDE