artisan ART2 Care And Use Manual
  1. Manuals
  2. Brands
  3. artisan Manuals
  4. Grill
  5. ART2
  6. Care and use manual

artisan ART2 Care And Use Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ART2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for artisan ART2

Summary of Contents for artisan ART2

  • Page 2 BARBECUE SERIAL NUMBER LABEL: NOTES:...

  • Page 3: General Safety Precautions

    Artisan A division of Superior Equipment Solutions, Inc. 7039 East Slauson Avenue Commerce, CA. 90040 3020914 Ph.: (888) 383-8800 Fax: (323) 726-4700 Web: GENERAL SAFETY PRECAUTIONS: WARNING WARNING FLAMMABLE GAS ELECTRICAL PARTS DISCONNECT ALL PROPANE AND COMPONENTS OR NATURAL GAS SUPPLIES...
  • Page 4 KEEP THIS MANUAL FOR FUTURE REFERENCE. When properly cared for, your ARTISAN™ Grill will give safe, reliable service for many years. However, extreme care must be used since the grill produces intense heat, which can increase accident potential. When using this appliance, basic safety practices must be followed, including but not limited to the following: Begin by ensuring proper assembly.
  • Page 5 (Safety, cont.) When lighting a burner, always pay close attention to what you are doing. Be certain you are  depressing the correct button, labeled for the igniter. When using the grill: do not touch the grill rack, burner grate, hood or immediate surrounding area as ...
  • Page 6 5. To comply with safety and service requirements, main gas shut off valve must be accessible from front of grill without using any tools. Your Artisan™ Grill has provision for mounting onto a mobile cart if you choose to do so. Contact your Artisan™ dealer for the appropriate cart for your grill.

  • Page 7: Important Electrical Instructions

    WARNING: To prevent harm and ensure proper operation of your grill, it is imperative that the burners are properly installed with respect to the gas orifices. Be certain that the orifice is inserted completely into the burner’s inlet and that the burner rests firmly on its support bracket. The burner should not rock side-to-side nor top-to-bottom if properly installed.
  • Page 8 TILE TRAY INSTALLATION: Remove top grill. Tile tray located over the gas burners GAS CONNECTION - LIQUID PROPANE (LP): NOTE: THIS APPLIES TO LP MODELS ONLY. LP MODELS HAVE THE LETTERS “LP” IN THE MODEL NUMBER. NEVER CONNECT THE GRILL TO AN UNREGULATED GAS SUPPLY. Before proceeding, ensure the unit is fitted for LP gas.
  • Page 9 LP GAS CONNECTION TO LP TANKS: Your ARTISAN™ Grill for use with LP gas is supplied with a high capacity, hose/regulator assembly for connection to a standard 20 Lb. LP cylinder. The LP gas pressure regulator and hose supplied with this unit must be used without alteration.
  • Page 10 SUPPLY HOSE DOES emergency gas shutoff. NOT COME IN CONTACT Your ARTISAN™ Grill for use with Natural Gas comes equipped WITH THE GRILL BODY with its own regulator which is shipped loose but must be installed.

  • Page 11: Leak Testing

    LEAK TESTING: GENERAL: Although all gas connections on your ARTISAN™ Grill are leak tested at the factory prior to shipment, a complete gas tightness check must be performed at the installation site due to possible mishandling in shipment, or excessive pressure unknowingly being applied to the unit.

  • Page 12: Lighting Instructions

    Make a soap solution of one part liquid detergent and one part water for leak testing purposes.  Apply the solution to the gas fittings by using a spray bottle, or brush.  For LP units, always check with a full cylinder. ...
  • Page 13 Keep your face away from the grill as far as possible and pass a lit, long stem match through the notch in the grill rack to the ports of the burner you are trying to light. When attempting to light a burner with a match, ensure that the correct burner control knob is used.

  • Page 14: Burner Adjustments

    SIDE BURNER LIGHTING: When lighting, always keep your face and body as far away as possible from the burners. Push and turn the side burner right hand control knob to the “HI” position and immediately depress the igniter button. You’ll hear a snapping sound from the spark which is being generated at the side burners. It is necessary to keep the igniter button depressed until the burner is lit.
  • Page 15 NOTE: Artisan™ grills are available with both U-burners and IR burners. The following instructions apply only to the U-burners. IR burners do not require adjustment and need only be checked visually for proper performance. On high, an IR burner should glow red evenly over its entire surface.

  • Page 16: Adjustment Steps

    LOW HEAT SETTING ADJUSTMENT: WARNING NOTE: THE LOW HEAT SETTING ON YOUR NEVER ADJUST THE BURNER SO LOW THAT IT MAY GRILL IS PRESET AT THE FACTORY. GO OUT DURING USE. DO NOT OPERATE THE ADJUST ONLY IF ALTITUDE OR ENVI- GRILL WITH THE LOW HEAT SCREW REMOVED.

  • Page 17: Rotisserie Burners

    DO NOT leave the grill unattended while cooking. ROTISSERIE BURNERS: Your ARTISAN™ Grill is capable of performing back burner rotisserie cooking. The location of the rear burner allows the placement of the rotisserie basting pan (not included) beneath the food to collect juices and drippings for basting and gravy.

  • Page 18: Rotisserie Motor

    To assure that an IR burner is lit, very carefully place your hand 8-10 inches away from the burner sur- face. If you do not feel the heat of the burner, shut off control knob, wait five minutes, and attempt to re- light.
  • Page 19 8 ~ 10 CHICKEN BREAST (BONE-IN) 20 ~ 24  These are recommended times only. Due to the variations on the cuts of meats and personal taste, your cooking times may be different. Use your discretion when cooking with ARTISAN™ Sear-Zone™ IR-Burners.

  • Page 20: Stainless Steel Care

    7. If necessary, dry the Grill after use with a soft dry cloth or towel. If the preceding guidelines are adhered to, your ARTISAN™ Grill should offer excellent life and should live up to its reputation of being “stainless”.

  • Page 21: Grill Rack

    Bleaches: Most common domestic bleaches & sterilizing solutions contain chlorine in the form of sodium hypochlorite. If used in concentrated form, bleaches can attack the stainless steel, causing pitting of the surface. They should always be used to the strengths prescribed by the manufacturer and should be thoroughly rinsed off with clean water immediately after use.

  • Page 22: Orifice Cleaning

    To maintain the appearance of your ARTISAN™ Grill for many years, keep it covered when not in use. Backyard environments are harsh on your grills’ finish. Long exposure to sun, water, yard chemicals and the elements will reduce the appearance of the stainless steel.

  • Page 23: Troubleshooting

    TROUBLESHOOTING: BEFORE CALLING FOR SERVICE: If your ARTISAN™ Grill does not function properly, use the following checklist before contacting your dealer for service. You may save the cost of a service call and the inconvenience of being without your grill.
  • Page 24 LIGHT BULB REPLACEMENT: NOTE: Disconnect all power to your Artisan™ grill before any service or light bulb replacement is performed. Light bulbs are located on the left and right side of the rear hood above the cooking area. The area around the light fixtures and the light fixtures themselves become extremely hot during grill operation with or without the lights being turned on.

  • Page 25: Light Cover

    Should you need to replace the light bulb in you Artisan™ Grill, please refer to the following steps : LIGHT COVER REMOVE THE LIGHT COVER The light cover is supported by a spring mechanism on the light fixture. Simply pry open the light cover from the left or right side by hand only.
  • Page 26 This is even more important when long term storage is intended; always store the grill clean, dry and covered with your Artisan™ barbecue cover. Also, do not allow any food particles or grease to be left inside your barbecue, as this will attract rodents which, in addition to being undesirable from an hygienic standpoint, are likely to cause physical damage to your barbecue.
  • Page 27 3. Either insert a new battery or replace the old battery with a new battery. 4. Replace the battery cap (rotate clockwise as viewed from below). 5. Slide the drip tray back in place. Note: All ART2 models have 115 V ignition. No batteries are required.
  • Page 28 FOR WARRANTY CLAIMS PLEASE CALL: (866) 203 5607...

  • Page 29: Service & Replacement Parts

    All replacement components, such as valves, etc, must be an Artisan product. Artisan’s warranty only applies to the original purchaser and may not be transferred, and commences from the date of purchase, and is valid only with proof of purchase.

This manual is also suitable for:

Aae

Table of Contents