Uniden U2 DB-CP Instruction Manual page 13

LIGHTNING SURGE PROTECTOR
The lightning surge protector can be installed indoors or outdoors. When connecting outdoors, install
the lightning surge protector inline between the signal (outdoor) antenna and the coaxial cable. When
connecting indoors, install the lightning surge protector inline between the outdoor coaxial cable and the
booster.
IMPORTANT: Lightning surge protector must be grounded. Connect a ground wire to
the appropriate place on the lightning surge protector and connect the other end to a
verified ground source.
INSTALL THE DISTRIBUTION
Select the installation location of your supplied distribution (indoor) antenna based on the following:
DOME OMNI DIRECTIONAL ANTENNA
Place in the center of the area where the signal needs to be amplified.
PANEL DIRECTIONAL ANTENNA
Place in the outer perimeter of the area the signal needs to be amplified.
WHIP OMNI DIRECTIONAL ANTENNA
Mount directly to the connector marked "indoor" on the cellular booster.
CONNECTING THE DISTRIBUTION
DOME OMNI DIRECTIONAL ANTENNA
Connect one end of the coaxial cable to the dome antenna and the other end to the cellular booster where it
is marked "indoor".
PANEL DIRECTIONAL ANTENNA
Connect one end of the coaxial cable to the panel antenna and the other end to the connector on the cellular
booster where it is marked "indoor".
WHIP OMNI DIRECTIONAL ANTENNA
Connect the antenna's end directly to the connector on the cellular booster where it is marked "indoor".
(INDOOR)
Canadian Head Office
5005 Jean-Talon Street West #10
Montreal, Quebec, Canada H4P1W7
The Uniden trademark is owned by Uniden America Corporation and its affiliates is used under license by Signifi Mobile.
BOOSTER KITS
Instruction Manual
- (SOLD SEPARATELY)
ANTENNA
ANTENNA
(INDOOR)
13
Phone: 1-888-744-9797
Email: info@cellularbooster.com
www.cellularbooster.com