Download Print this page

BYOU CB/BY Quick Manual

Emergency battery kit

Advertisement

Quick Links

L8542497 ENG 10/2009 rev 0
Emergency battery kit
CB.BY
MADE IN ITALY
1

Advertisement

loading

Summary of Contents for BYOU CB/BY

  • Page 1 L8542497 ENG 10/2009 rev 0 Emergency battery kit CB.BY MADE IN ITALY...
  • Page 2: Product Description

    TY, FREEDOM and BEAUTY units made by teries and the control station using the ca- BYOU, and allows the device to work tem- bles supplied. The board automatically pow- porarily when there is no mains power.
  • Page 3 Installation on JUMP unit Cut off the mains power supply before carrying Disconnect the battery charger connector out any operation. (shown in the fi gure) from the control station’s cover: Using a screwdriver, open the passage for the cables (A). If necessary, lower the gearmotor as described in the instructions for the JUMP unit: On the battery charger, re-...
  • Page 4 Installation on PRETTY unit Cut off the mains power supply before carrying On the battery charger, re- out any operation. move the screw on the side opposite the terminal board. Remove the protective casing from the gear- motor with the control station (PRETTY.A) following the instructions supplied with the Using the screw supplied, install the battery PRETTY unit.
  • Page 5 Installation on BEAUTY unit Cut off the mains power supply before carrying Put the battery charger in the position shown out any operation. in the fi gure (no screws are required): Open the control station, following the instruc- tions supplied with the BEAUTY unit. Install the batteries using the relative bracket and screws as shown in the fi...
  • Page 6 Installation on FREEDOM unit Cut off the mains power supply before carrying Fasten the battery charger as shown in the out any operation. fi gure, applying double-sided adhesive tape in zone B: Open the electromechanical operator with the control station following the instructions sup- plied with the FREEDOM unit.
  • Page 7 Connections Cut off the mains power supply before carrying out any operation. Connect cable A from the batteries to cable B on the battery charger: Connect the battery charger to the control unit using cable C (supplied):...