Introduction; Installation; Software; Hardware - Codex CAPTURE DRIVE DOCK Getting Started Manual

Capture Drive Dock (USB-3) - Getting Started Guide

Introduction

The Codex Capture Drive USB Dock is the hub of your file-based workflow. It can easily be
configured to produce a full set of deliverables – everything you need for your production and
post, from viewing copies to archives. It can provide them all in less time than traditional systems
take to make a single copy.

Installation

Important Note: Do not connect the USB Dock to your computer until you have installed all
required software and restarted your computer.

Software

Go to codexdigital.com/software to register and download software. There are installation
instructions available from this webpage.
The software webpage is divided into sections. It is recommended to download the newest
version (at the top of each section) of each required software component when first installing a
system. To use the USB Dock the following software components must be installed:
Required software component
Codex Server
Codex UI
OSXFUSE
Note: All software is in the 'Codex Transfer Station and USB Dock software for OS X' section
except for the Codex UI software, which is in the 'Codex User Interface software for OS X'
section.

Hardware

After installing the software and restarting your computer, connect power to the USB Dock.
Then connect the USB Dock to a USB 3.0 port on your computer. Use only the supplied USB 3.0
cable and power supply.
CODEX CAPTURE DRIVE DOCK (USB-3) - GETTING STARTED GUIDE v1.0 CDX-D0C-0038
Example filename
codexserver-osx-2012.r2.2610.dmg
codexui-osx-2012.r2.2610.dmg
OSXFUSE-2.5.1
PAGE 4