1. Manuals
  2. Brands
  3. Dynalink Manuals
  4. Wireless Access Point
  5. RTA300W
  6. Operation and setup manual

Dynalink RTA300W Operation And Setup Manual

Adsl router + wlan access point
Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

ADSL Router +
WLAN Access Point
Supplement for Wireless Operation and Setup
RTA300W
NOTE: This supplement only concerns the wireless
operation of the RTA300W. It complements the enclosed
Dynalink ADSL Router Quick Setup Guide. Please refer
to the Quick Setup Guide for all other topics.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RTA300W and is the answer not in the manual?

Questions and answers

Summary of Contents for Dynalink RTA300W

  • Page 1 WLAN Access Point Supplement for Wireless Operation and Setup RTA300W NOTE: This supplement only concerns the wireless operation of the RTA300W. It complements the enclosed Dynalink ADSL Router Quick Setup Guide. Please refer to the Quick Setup Guide for all other topics.
  • Page 2 Ethernet network (LAN). On a Wireless LAN computers are linked together by radio waves. The RTA300W is your Internet access point and it is also your WLAN access point. It provides sharing of network resources including Internet access among wireless clients and wired clients.
  • Page 3 Setup wireless networking The wireless function of your RTA300W is activated by default. The WLAN light comes on indicating the wireless interface is ready. By default, Association Control and WEP encryption are disabled. STEP 1 (or peer-to-peer) mode. Check that...
  • Page 4 ASSOCIATION CONTROL By default every client having the same SSID is capable of connecting to the RTA300W. Association control is used for blocking access from unauthorised clients. Go to the router control panel. Then Configuration - WLAN - Association Control.
  • Page 5 E.g. If you are using a Dynalink wireless client Run the Monitor Utility. Go to Encryption. Select the correct key length 64 /128 Bit to match the RTA300W setting. Click on HEX and copy the values of all keys displayed from the RTA300W into the corresponding...

  • Page 6: Troubleshooting

    Troubleshooting Cannot establish a wireless link to the RTA300W Check that the WLAN light on the front panel of the RTA300W is on. Make sure the RTA300W and wireless clients are configured with the same SSID. If Association Control is enabled, check that the client’s MAC address has been entered into the list of authorised clients on the RTA300W.

Table of Contents