On-Q lyriQ 15-0391 Instruction/Installation Sheet

on-Q
tllegrand®
INSTRUCTION/INSTALLATION SHEET
lyriQTM Keypad Volume Control
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
15-0391 REV. 0
www.onqlegrand.com
1. Introduction
The lyriQTM Keypad Volume Control, PIN AU7394-xx (see Figure 1), is an integral
part of the lyriQTM Multi-Room Audio System. It is a component which, when
combined with other essential components and your source equipment (receiver,
CD player, etc.), creates a versatile whole-house audio system that will fill your
rooms with high-quality sound for years to come. It
USE::S
Category 5 wiring to
distribute audio signals, control information and IR for remote control. The Keypad
has two on-board 7 Watt class 0 amplifiers to provide a rich level of clean sound. It
also contains a full set of features, including the integrated ability to control all other
keypad volume controls in the house. It is available in White (-WH), Light Almond (-
LA), Ivory (-IV), or Black (-BK).
2. Description
The front panel of the lyriQTM Keypad Volume Control (see Figure 1), contains push
buttons for VOLUME UP/DOWN (with five associated green Volume Bar Graph
LEOs), SOURCE (with four green Source Selection LEDs) and MUTE (with one red
status LED). There is also an IR target window and tri-colored status LED.
The rear of the lyriQTM Keypad Volume Control (see Figure 2) contains an RJ45 jack
(J1) for connection to the lyriQTM Audio Distribution Module. The TB2 speaker output
connections (left and right, plus and minus) are spring loaded and designed to
support up to 14 gauge wire. The TB1 Line Out connections (left and right, plus and
minus) are also spring loaded and designed to support up to 14 gauge wire. This
output is designed for devices such as powered sub-woofers.
3. Installation
Installation of the lyriQTM Keypad Volume Control is best accomplished at multiple
times during new construction, at "Rough-in" before the drywall is installed, and at
"Trim-out" after the drywall is installed and painted.
NOTE: Before connecting the volume controls: Make sure that power supplies
are not connected to the lyriQTM Audio Modules. For instructions on pre-wiring
and installing other components of the lyriQTM Audio System, please see the
Instruction Sheets included with those components.
Figure 1
Figure 2
NOTE: All wiring should be terminated to the T568A wiring standard. Failure to follow the correct wiring
standard could result in damaged equipment.
A. "Rough-in" steps:
1) A single Category 5 cable should be run from the enclosure location to a single gang outlet box or mud
ring at each Volume Control location.
©Copyright 2007 by On-Q/Legrand All Rights Reserved. Page 1 of 5