Warranty; Certifications And Precautions; Safety Information - Wavetek Meterman FG2C Operator's Manual

O '
English
P E R A T O R
FG2C/FG3C Function Generator

WARRANTY

The FG2C and FG3C Function Generators are warranted against any defects of material or workmanship within a period of one (1)
year following the date of purchase of the Function Generator by the original purchaser or original user. Any Function Generator
claimed to be defective during the warranty period should be returned with proof of purchase to a Wavetek authorized Service Center
or to the local Wavetek dealer or distributor where the Function Generator was purchased. See maintenance section for details. Any
implied warranties arising out of the sale of a Wavetek Function Generator, including but not limited to implied warranties of
merchantability and fitness for a particular purpose, are limited in duration to the above stated one (1) year period. Wavetek shall not
be liable for loss of use of the Function Generator or other incidental or consequential damages, expenses, or economical loss or for
any claim or claims for such damage, expenses or economical loss. Some states do not allow limitations on how long implied
warranties last or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not
apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from state to state.

CERTIFICATIONS AND PRECAUTIONS

This instrument is EN61010-1:1993 certified for Installation Category II, Pollution Degree II. All inputs are protected against
continuous overload conditions up to the limits of each function's stated input protection (see specifications). Never exceed these
limits or the ratings marked on the instrument itself. Always inspect your Function Generator, test leads and accessories for signs of
damage or abnormality before every use. If an abnormal condition exists (broken or damaged test leads, cracked case, display not
reading, etc.), do not use. Never ground yourself when taking measurements. Do not touch exposed metal pipes, outlets, fixtures,
etc., which might be at ground potential. Keep your body isolated from ground and never touch exposed wiring, connections, test
probe tips, or any live circuit conductors. Do not operate instrument in an explosive atmosphere (flammable gases, fumes, vapor,
dust.) Do not use this or any piece of test equipment without proper training.
DANGER High Voltage
ATTENTION Refer to Manual
Protective Conductor Terminal
Frame or Chassis Terminal
FOR UNITED KINGDOM ONLY
NOTE: This lead/appliance must only be wired by competent persons
WARNING: THIS APPLIANCE MUST BE EARTHED
IMPORTANT: The wires in this lead are coloured in accordance with the following code:
E
L
N
M
S A N U A L
Green/Yellow Earth
Blue Neutral
Brown: Live (Phase)
WARNING: To avoid electrical shock, the power cord protective
grounding conductor must be connected to ground.
CAUTION: To avoid damaging the instrument, do not use it in a place
where ambient temperature exceeds 40°C.
CAUTION: To avoid damaging the instrument, do not input more than
15VDC to VCF.
CAUTION: To avoid damaging the instrument, do not input more than
150VAC to Frequency Counter (FG3C only).
CAUTION: To avoid damaging the instrument, do not input more than
10Vpp during EXT modulation operation (FG3C only).
- 1 -