Advertisement
Keep portable heaters and open flames such as candles away
from combustible materials.
Do not allow rubbish to accumulate.
Do not leave small children home alone.
c. Develop a family escape plan and practice it with your entire
family, especially small children.
Draw and post a floor plan of your home and find two ways to exit
from each room. There should be one way to get out of each
bedroom without opening the door.
Teach children what the smoke alarm signal means, and that they
must be prepared to leave the residence by themselves if
necessary. Show them how to check to see if doors are hot before
opening them, how to stay close to the floor and crawl if
necessary, and how to use the alternate exit if the door is hot and
should not be opened.
Decide on a meeting place a safe distance from your house and
make sure that all your children understand that they should go
and wait for you if there is a fire.
Hold fire drills at least every 6 months to make sure that everyone,
even small children, know what to do to escape safely.
Know where to go to call the fire department from outside your
residence.
Provide emergency equipment such as fire extinguishers and
teach your family to use this equipment properly.
d. Bedroom doors should be closed while sleeping if a smoke
alarm is installed in the bedroom. They act as a barrier
against heat and smoke.
WHAT TO DO IF THERE IS A FIRE IN
YOUR HOME
If you have prepared family escape plans and practiced them
with your family, you have increased their chances of escaping
safely. Review the following rules with your children when you have
fire drills so everyone will remember them in a real fire emergency.
If the alarm should sound:
a. Don't panic; stay calm. Your safe escape may depend on thinking
clearly and remembering what you have practiced.
b. Get out of the house following a planned escape route as quickly
as possible. Do not stop to collect anything or to get dressed.
c. Open doors carefully only after feeling to see if they are hot. Do
not open a door if it is hot; use an alternate escape route.
d. Stay close to the floor; smoke and hot gases rise.
e. Cover your nose and mouth with a cloth, wet if possible, and take
short, shallow breaths.
f. Keep doors and windows closed unless you open them to escape.
g. Meet at your prearranged meeting place after leaving the house.
h. Call the Fire Department as soon as possible from outside your
house. Give the address and your name.
i. Never re-enter a burning building.
Contact your local Fire Department for more information on
making your home safer from fires and about preparing your family's
escape plans.
NOTICE: Current studies have shown smoke
alarms may not awaken all sleeping individuals,
and that it is the responsibility of individuals in the
household that are capable of assisting others to
provide assistance to those who may not be
awakened by the alarm sound, or to those who
may be incapable of safely evacuating the area
unassisted.
WHAT THIS SMOKE ALARM CAN DO
This smoke alarm is designed to sense smoke entering its
sensing chamber. It does not sense gas, heat (except for the H or T
options), or flames.
When properly located, installed, and maintained, this smoke
alarm is designed to provide early warning of developing fires at a
reasonable cost. This unit monitors the air and, when it senses
smoke, activates its built-in alarm horn. It can provide precious time
for you and your family to escape from your residence before a fire
spreads. Such an early warning, however, is possible only if the
smoke alarm is located, installed, and maintained as specified in this
User's Manual.
NOTICE: This smoke alarm is designed for use within single
residential living units only; that is, it should be used inside a
single-family home or one apartment of a multi-family building.
In a multi-family building, the device may not provide early warning
for residents if it is placed outside of the residential units, such as on
outside porches, in corridors, lobbies, basements, or in other
apartments. In multi-family buildings, each residential unit should
have smoke alarms to alert the residents of that unit. Units designed
to be interconnected should be interconnected within one family
residence only; otherwise, nuisance alarms will occur when a smoke
alarm in another living unit is tested.
IMPORTANT NOTICE: WHAT SMOKE
ALARMS CANNOT DO
Smoke alarms will not work without power. A battery must be
connected to the device to maintain proper alarm operation if device
AC power supply is cut off by an electrical fire, an open fuse or
circuit breaker, or for any other reason. In the event of AC power
failure, the battery will supply power for a minimum of 24 hours.
Smoke alarms may not sense fire that starts where smoke
cannot reach the devices such as in chimneys, in walls, on roofs,
or on the other side of closed doors. If bedroom doors are usually
closed at night, smoke alarms should be placed in each bedroom as
well as in the common hallway between them.
Smoke alarms also may not sense a fire on another level of
a residence or building. For example, a second-floor device may
not sense a first-floor or basement fire. Therefore, smoke alarms
should be placed on every level of a residence or building.
The horn in your smoke alarm meets or exceeds current audibility
requirements of Underwriters Laboratories. However, if the smoke
alarm is located outside a bedroom, it may not wake up a sound
sleeper, especially if the bedroom door is closed or only partly open.
If the smoke alarm is located on a different level of the residence
than the bedroom, it is even less likely to wake up people sleeping in
the bedroom. In such cases, the National Fire Protection
Association recommends that smoke alarms be interconnected so
that a unit on any level of the residence will sound an alarm loud
enough to awaken sleepers in closed bedrooms. This can be done
by installing a fire-detection system, by connecting smoke alarms
together, or by using radio frequency transmitters and receivers.
All types of smoke alarm sensors have limitations. No type
of device can sense every kind of fire every time. In general,
smoke alarms may not always warn you about fires caused by
violent explosions, escaping gas, improper storage of
flammable materials, or arson.
NOTICE: This smoke alarm is not designed to replace special-
purpose fire detection and smoke alarm systems necessary to
protect persons and property in non-residential buildings such as
warehouses, or other large industrial or commercial buildings. It
alone is not a suitable substitute for complete fire-detection systems
designed to protect individuals in hotels and motels, dormitories,
hospitals, or other health and supervisory care and retirement
homes. Please refer to NFPA 101,The Life Safety Code, and NFPA
72 for smoke alarm requirements for fire protection in buildings not
defined as "households."
Installing smoke alarms may make you eligible for lower
insurance rates, but smoke alarms are not a substitute for
insurance. Home owners and renters should continue to insure
their lives and property.
PLACEMENT OF SMOKE ALARMS
THIS EQUIPMENT SHOULD BE INSTALLED IN
ACCORDANCE WITH THE NATIONAL FIRE PROTECTION
ASSOCIATION'S STANDARD 72 (National Fire Protection
Association, Batterymarch Park, Quincy, MA 02269).
For your information, the National Fire Protection Association's
Standard 72, reads as follows:
NFPA 72, 2007 Edition, Chapter 11, Section 11.5.1.1 Where
required by applicable laws, codes or standards for a specific type of
occupancy, approved single and multiple-station smoke alarms shall
be installed as follows:
1) In all sleeping rooms and guest rooms
2) Outside of each separate dwelling unit sleeping area, within 6.4m
(21ft) of any door to a sleeping room, the distance measured
along a path of travel
3) On every level of a dwelling unit, including basements
4) On every level of a residential board and care occupancy (small
facility), including basements and excluding crawl spaces and
unfinished attics
5) In the living area(s) of a guest suite
550-0093
Pg. 9-2
Advertisement
