Subscribe to Our Youtube Channel
Summary of Contents for Comfort audio Comfort Digisystem Programmer DT05
- Page 1 Comfort Digisystem User manual Comfort Digisystem Programmer DT05 North America / English...
-
Page 2: Table Of Contents
User manual Table of contents Page 1) Introduction Comfort Digisystem 2) Regulatory information 3) Functions Programmer DT05 - professional tool 4) Included accessories 5) Programmer DT05 6) Menu Programmer DT05 7) Instructions HA scanner in Programmer DT05 8) Battery maintenance 9) Technical data 10) Radio range and channels 11) Trouble shooting... -
Page 3: Introduction Comfort Digisystem
This equipment has been tested and found to comply with the vided by Comfort Audio. Comfort Audio shall not be liable for limits for a Class B digital device, pursuant to Part 15 of the performance problems and/or damages caused in any way FCC Rules. -
Page 4: Functions Programmer Dt05 - Professional Tool
3) Functions Programmer DT05 - optional professional tool Function indicator Volume button - Socket for Volume button + neckloop On / Off Charging socket Menu control Pairing button Socket for headphones / earphones 4) Included accessories Volume indicator • Headphones • Charger A11 Europlug socket Programmer DT05... -
Page 5: Programmer Dt05
6) Menu in the Programmer DT05 5) Programmer DT05 The Programmer DT05 is an optional professional tool that can be used both for configuring and test-listening R enable of the DT10. R+M enable The Programmer DT05 can be used to configure one setting at a time in the Receiver DT10. -
Page 6: Instructions Ha Scanner In Programmer Dt05
Pairing Always on When Pairing is selected, the DT10 can be set to pairing The setting Always on , disables the off-function of the mode by pressing the push-button for two seconds. push-button, leaving the Receiver DT10 always on. The If Pairing isn’t selected, pairing mode cannot be enabled Receiver DT10 is turned off when turning off the Hearing with the push-button. -
Page 7: Programmer Dt05
7) Instruction HA scanner in Programmer DT05 The HA scanner is used for detecting how much inter- ference there is from a hearing aid, within the frequency band that the Receiver DT10 is operating in. How to use the scanner: Enter Setting in the menu of the Programmer DT05 to activate the scanner. -
Page 8: Battery Maintenance
Special charg- Comfort Audio is not liable for unauthorized use of radio ing circuits in the Digisystem products protect batteries waves, such as, but not limited to: interferences with from overcharging. -
Page 9: Trouble Shooting
12) Service and warranty Warranty extension The receiver does not start Comfort Audio Inc. warrants this product sold to the 1. Check that the correct listening program is selected first end user (buyer) against defects in materials or on the hearing instrument. -
Page 10: Important Safety Instructions
13) Important safety instructions - 20) Only use batteries and power supply specified by Comfort Audio AB. Read these before using your product 21) You must not change the battery yourself; please contact your point of purchase. Read these instructions. - Page 11 Comfort Audio AB, Box154, SE-301 05 Halmstad, Sweden Tel. +46 (0)35 260 16 00 Fax +46 (0)35 260 16 50 Local US office: Comfort Audio Inc, 350 South Northwest Hwy, Ste 300 Park Ridge, IL 60068 USA T (847) 656 5450...
Need help?
Do you have a question about the Comfort Digisystem Programmer DT05 and is the answer not in the manual?
Questions and answers