Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Laney CP10
Summary of Contents for Laney CP10
- Page 1 Laney Series monitors MODEL : CP10 CP12 CP15 CM10 CM12 CM15 USER MANUAL...
-
Page 2: Save These Instructions
Concept IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electric products, basic cautions should always be followed, including the following. Read all safety and operating instructions before using this product All safety and operating instructions should be retained for future reference Obey all cautions in the Operating instructions and on the back of the unit All operating instructions should be followed This product should not be used near water, i.e. -
Page 3: Important Safety Information
Concept THANK YOU We at Laney are extremely pleased that you have decided to select a Concept product for your sound requirements and we wish to reinforce your judgement by ensuring you get off to a flying start by including this comprehensive user manual to assist you in getting to know your equipment. -
Page 4: External Speaker
- 0+ BASS: Adjusts the monitors LO frequency Treble response. EXTERNAL SPEAKER: Output socket - 0+ - 0+ for connect further un powered Laney monitor such as CM10, CM12 or CM15. Bass POWER: Power On/Off switch. Power Ext. Ext. Speaker... -
Page 5: Frequency Response
BASS: Adjusts the monitors LO frequency - 0+ - 0+ response. Bass EXTERNAL SPEAKER: Output socket for connect further un powered Laney Power monitor such as CM10, CM12 or CM15. Ext. Ext. Speaker Speaker POWER: Power On/Off switch. - Page 6 - 0+ - 0+ BASS: Adjusts the monitors LO frequency Bass response. EXTERNAL SPEAKER: Power Output socket for connect further un powered Laney Ext. Ext. Speaker Speaker monitor such as CM10, CM12 or CM15. 8 Ohms Min 8 Ohms Min POWER: Power On/Off switch.
- Page 7 Each CM monitor is supplied with an input jack and a link out jack. The input jack should be used to recieve the signal from the External Speaker Socket on a CP10, CP12 or CP15, whilst the link out jack should be used only when the monitors are being powered by a dedictaed monitor power amplifier, for example when the mixing desk is sending a monitor signal to an additional power amplifier.
Need help?
Do you have a question about the CP10 and is the answer not in the manual?
Questions and answers