D-Link N300 Quick Start Manual page 3

D-Link N300 Setup Guide
®
The D-Link® N300 Modem Router from ACN has been setup to Plug-and-Play.
To setup your device follow these steps:
Step 1 - Your Equipment
Once you have received your ADSL activation email from us, take the
following equipment out of the box.
Router
Phone Cable
ADSL Splitter
Power Adaptor
Ethernet Cable
Step 2 - Connect Splitter
(not required for Naked DSL)
Connect the supplied splitter directly
to the telephone wall socket.
Step 3 - Connect Router
Connect the supplied grey telephone
cable from the splitter's ADSL port to
the grey ADSL port on the Modem Router.
Step 4 - Connect Your Home
Telephone (not required for
Naked DSL)
Connect your telephone to the phone
port on the splitter.
4
Step 5 - Connect PC
Connect the supplied yellow
Ethernet cable from the Modem
Router's yellow LAN port to your
computer's Ethernet port.
Step 6 - Connect Power
Connect the power adapter to the
router then plug it into an electrical
outlet. Ensure electrical outlet is ON.
Press the black power button at the
back of the router to turn on the
Modem Router.
Step 7 - Check Installation
1. If the power is connected correctly, the POWER LED will light up.
2. If the grey telephone cable and the splitter are connected
correctly, the ADSL LED will flash and after a few seconds turn
solid green.
3. Since the Modem Router is pre-configured the INTERNET LED
will turn green after a few seconds.
4. If the yellow Ethernet cable is connected correctly, the
corresponding ETHERNET (LAN) LED will light up.
5. Once you have confirmed the above, open your web browser
(e.g. Internet Explorer, Google Chrome, Firefox or Safari) and go
to your favourite website.
Congratulations, you are now connected to the Internet.
5