Connections With C-Series Contorllers - Russound ST1 smart tuner Installation Manual

CONNECTIONS WITH C-SERIES CONTROLLERS
After mounting the ST1 in the desired location, connections for audio,
communication, antenna signal, and power can be made.
First set the Source ID switch to the value representing the source input to be
used on the C-Series controller i.e. 2 = Source 2.
Next, connect the supplied RCA audio patch cables from the ST1 Audio
Outputs to the source audio inputs on the C-Series controller that match the
Source ID switch setting made.
Next connect the RNET Link cable from the ST1 to the C-Series controller or to
another RNET link port that exists in the Russound system such as that found
ST1
RNET Link
(CAT5)
MCA-C5
8
RCA Audio Cable
Russound ST1 Installation Manual
on another Russound source.
Then connect the AM and FM antennas. Make sure that the antennas are
positioned away from metal object or dense materials such as concrete to
improve reception.
Finally the AC power cable may be connected to the ST1 then plugged into
the electrical outlet.
75 to 300
Ohm Balun
To AM/FM Antenna
4-Way Coax
Splitter