Adjusting The Viewing Angle - D-Link DCS-6004L User Manual

Section 2: Installation
Please refer to the steps below to assist you with adjusting the viewing angle of the camera.
We suggest that you configure the camera before mounting.
1. The camera housing needs to be separated from the camera base to expose the screw used to
adjust the viewing angle. Remove the camera housing from the camera base by squeezing the
housing release buttons on either side of the camera.
2. Lift the camera housing up off the camera base once the housing has been released.
3. Use a philips head screwdriver to loosen the retaining screw used to secure the viewing angle of
the camera lens.
4. Manually adjust the viewing angle back and forth to your desired location.
5. Use a philips head screwdriver to tighten the retaining screw used to secure the viewing angle of
the camera lens.
Do not overtighten screw as this may crack the mount.
6. Reattach the camera housing by lining up the housing so that the access port on the housing
matches the access port on the camera base. Firmly push down until the camera housing snaps
back onto the camera base.
7. Refer to "Mounting the Camera" on page 12 to learn how to correctly mount the camera to its
permenant location.
D-Link DCS-6004L/DCS-6005L User Manual

Adjusting the Viewing Angle

1
2
3
4
5
6
13