Advertisement
Quick Links
6800 Temperature Controller Retrofit Kit (472099)
INSTALLATION ................................................................................................................ 2
WIRES IDENTIFICATION ............................................................................................... 2
WIRING .............................................................................................................................. 3
OPERATION ...................................................................................................................... 6
TROUBLESHOOTING ...................................................................................................... 7
RAIN PROTECTION ........................................................................................................ 9
PART LIST ........................................................................................................................ 10
Warning:
This product must be installed and serviced by a professional service technician qualified in
pool/spa heater installation and maintenance. If you do not follow these instructions exactly, a fire
or explosion may result, causing property damage, personal injury or loss of life. For additional
free copies of these instructions; call (800) 831-7133.
Attention Installer.
This manual contains important information about the installation, operation and safe use of this
product. This information should be given to the owner/operator of this equipment.
Pentair Pool Products, Inc.
1620 Hawkins Ave., Sanford, NC 27330
10951 W. Los Angeles Ave., Moorpark, CA 93021
Rev. B 4-16-02
MiniMax NT Heater Single Voltage
Installation Instructions
Table of Contents
FOR YOUR SAFETY - READ BEFORE OPERATING
Important Notice
(919) 774-4151
•
(805) 523-2400
•
WARNING
1
P/N 472091
Advertisement
Related Manuals for Pentair Pool Products 6800
Summary of Contents for Pentair Pool Products 6800
-
Page 1: Table Of Contents
MiniMax NT Heater Single Voltage 6800 Temperature Controller Retrofit Kit (472099) Installation Instructions Table of Contents INSTALLATION ........................ 2 WIRES IDENTIFICATION ....................2 WIRING ..........................3 OPERATION ........................6 TROUBLESHOOTING ...................... 7 RAIN PROTECTION ......................9 PART LIST ........................10... -
Page 2: Installation
(NOTE: Please discard the cover, not used.) Then, remove the cover, the PC board, and the front face carrier. 6. Install the 6800 Temperature Controller, (provided in the kit), by using four screws only. See Figure 1. 7. Remove two screws on existing Ignition Module and replace with new Ignition Module using the same two screws, (provided in the kit). -
Page 3: Wiring
• Please see Figure 2 for SVDS and follow the instructions below exactly. a. Reconnect existing wire P7 to J7, P9 to J9, and P10 to J10 respectively on the 6800 control board. b. Reconnect the existing white wire from Low Gas Pressure Switch to “TH” on the Ignition Module. - Page 4 P/N 472091 Rev. B 4-16-02...
- Page 5 Rev. B 4-16-02 P/N 472091...
-
Page 6: Operation
D. OPERATION Dual Temperature Control System POWER (THERMOSTAT SELECT) SWITCH For convenience and economy all MiniMax NT heaters are equipped with two thermostats on the front of the heater The Pool/Off/Spa switch allows the heater to be turned off control panel; see Figure 1. when heating is not desired. -
Page 7: Troubleshooting
INDICATOR LIGHT DESCRIPTION, (cont’d.) HEAT (HEAT) SERVICE (SERVICE) The heat light is on any time the thermostat has signaled a The service light is off during normal operation of heater. call for heat which initializes the ignition safety firing circuit - The light only comes on if a problem with a control has - the light comes on to indicate successful firing of the main occurred or when the heater is first firing. - Page 8 E. TROUBLESHOOTING, (cont’d.) SYMBOL TABLE SWITCH OR DEVICE SWITCH OR DEVICE OPEN CIRCUIT CLOSED CIRCUIT LED OFF LED LIT (BLOCK CURRENT) (PASS CURRENT) IGNITION MODULE GAS VALVE TRANSFORMER INCOMING CIRCUIT HI TEMP REMOTE PRESS TFUSE LINE VOLTAGE BREAKER LIMIT SWITCHES THERMOSTAT RELAY PRESS...
-
Page 9: Rain Protection
RAIN PROTECTION NOTE Please ignore the following steps in Section F if the heater has been installed with a rain protection shield. 1. Using the silicon tube (provided in the kit) to seal the 3 sides of the edge. See Figure 5. WARNING The edges of the heater door can be sharp. -
Page 10: Part List
Label, Wiring Diagram, NT LN SVDS, Model 400 Only 472086 Temperature Controller Assembly, 6800 472088 Label, Wiring Diagram, NT LN SVSS, Models 200/250/300 472091 Instruction Sheet, 6800 Retrofit Kit 472094 Splice (Self-Stripping Electrical Tap Connector) 472096 In-Line Fuse, 5 Amp. 472103... - Page 11 This page is blank. Rev. B 4-16-02 P/N 472091...
- Page 12 Pentair Pool Products, Inc. 1620 Hawkins Ave., Sanford, NC 27330 (919) 774-4151 • 10951 W. Los Angeles Ave., Moorpark, CA 93021 (805) 523-2400 • P/N 472091 Rev. B 4-16-02...
Need help?
Do you have a question about the 6800 and is the answer not in the manual?
Questions and answers