Advertisement
Quick Links
CE labs can support many areas of your audio and video
distribution needs.
We manufacture:
• Digital Signage software and Media Players
• HD Matrix Switchers
• RF amplifiers
• HDMI and Component HD distribution amplifiers
• CAT 5 Signal Extenders
• VGA Extenders and Splitters
• and cables of all types.
See our full product line at
www.celabs.net
WARRANTY
Cable Electronics, Inc. warrants this product to be free from defects in
material and workmanship, under normal use and service, for a period of
one year from the purchase by the original purchaser. If this product is
defective or malfunctions, Cable Electronics will replace or repair this unit
(at their option) within a reasonable time. No expressed or implied warranty
is made for any defects caused by immersion or exposure to liquids, abuse,
neglect, improper operation of unit, excess wear and tear and defects
resulting from unauthorized disassembly and or modification.
3209 Wood Drive
Garland, TX 75041
Phone: (469) 429-9200
Toll free: (800) 767-6189
Fax: (469) 429-9205
www.celabs.net
930_5036_01
REV_A1
Document: C5T6_manual.pdf
C5T6
Distribution Hub
Receiver/Transmitter
Distribute High Definition Video and Audio to
multiple locations over extended distances using
economical Cat 5 or Cat 6 cable. Input can be
RCA connector (for video and audio) or via Cat5
sent from a remote transmitter.
Advertisement
Summary of Contents for Cable Electronics C5T6
- Page 1 See our full product line at www.celabs.net WARRANTY Cable Electronics, Inc. warrants this product to be free from defects in material and workmanship, under normal use and service, for a period of one year from the purchase by the original purchaser. If this product is defective or malfunctions, Cable Electronics will replace or repair this unit (at their option) within a reasonable time.
- Page 3 DISTRIBUTION HUB FEATURES • The CAT5 T6 (C5T6) has one set of RCA inputs and one set of RCA loop-thru connectors (to go to the next Transmitter or a local monitor) and two RJ-45 jacks CAT5 signal inputs, if both signals are present at same time (RCA and CAT5), the RCA input signal will be selected automatically.
- Page 4 2. Connect the source device component video/audio outputs to the appropriate input jacks on the C5T6. The loop out jacks can be used to feed a local monitor or cascade I. Note: Do not connect a Loop Out cable unless the other end is plugged into a monitor or other 75 ohm impedance device.