Table of Contents
Advertisement
Important Laser Safety Measures and Notices
Before using this product and any associated equipment, refer to the sections below so as to avoid
personnel injury and to prevent product damage. For further safety information when using fiber
products, consult the following publications:
Products may require specific equipment, and /or installation procedures be carried out to satisfy
certain regulatory compliance requirements.
Caution
familiar with laser safety and fiber handling practices.
Safety Measures for Operation
During normal operation of this product, heed the following safety measures:
Safety Measures for Maintenance and Servicing
Warning
to stare at the energized fiber end. Doing so may damage your eyes.
During maintenance and servicing of this product, only properly trained and authorized personnel
shall be allowed to use optical test or diagnostic equipment.
Laser Information
CLASS 1 LASER PRODUCT
IEC 60825-1:2007
Caution
THE BEAM.
•
IEC-60825- 2, Safety of Laser Products - Part 2: Safety of Optical Fiber
Communication Systems (OFCS) (for use outside of the U.S.A.)
•
ANSI Z136.2, Safe Use of Optical Fiber Communication Systems Utilizing Laser
Diode and LED Sources (for use in the U.S.A.)
— Before operating or servicing this product, all personnel should be
•
Do not stare at, or into, broken, or damaged, fibers.
•
Do not stare at, or into, optical connectors.
•
Only properly trained and authorized personnel shall be permitted to perform laser/fiber
optic operations.
•
Ensure that appropriate labels are displayed in plain view and in close proximity to the
optical port on the protective housing/access panel of the terminal equipment.
— Do not use optical equipment, such as a microscope or an eye loupe,
— INVISIBLE LASER RADIATION WHEN OPEN. AVOID EXPOSURE TO
Advertisement
Table of Contents
