Download Print this page

Ultramax Ultrapower UXDS-3 Quick Start Manual

Underwater digital strobe light

Advertisement

Quick Links

Preparing the UXDS- - - - 3 3 3 3 Strobe for Use
Preparing the UXDS
Preparing the UXDS
Preparing the UXDS
Step 1
Battery installation
Battery installation
Battery installation
Battery installation
Unscrew the large knob giving access to the battery compartment.
You will feel some resistance as there are two O-rings providing positive protection against leakage.
Upon removal you can see the battery holder inside the compartment – slide this out
Step 2
Install four AA batteries in the holder paying close attention to polarity
(CAUTION : Installing batteries in WRONG polarities may cause heat to damage the battery holder and
the electronic components. Please install the batteries according to the polarity icons embossed on
both sides of the battery holder. Damage caused by incorrect battery installation is NOT covered
under warranty.)
Step 3
Following the position markings, snap the two Battery Holder Cover Plates onto both sides of the
Battery Holder
ULTRAMAX
ULTRAPOWER UXDS-3
UNDERWATER DIGITAL STROBE LIGHT
QUICK START GUIDE
Strobe for Use
Strobe for Use
Strobe for Use

Advertisement

loading

Summary of Contents for Ultramax Ultrapower UXDS-3

  • Page 1 ULTRAMAX ULTRAPOWER UXDS-3 UNDERWATER DIGITAL STROBE LIGHT QUICK START GUIDE Preparing the UXDS Preparing the UXDS- - - - 3 3 3 3 Strobe for Use Preparing the UXDS Preparing the UXDS Strobe for Use Strobe for Use Strobe for Use...
  • Page 2 Step 4 Replace battery holder to battery compartment. (It can only be inserted when it’s groove is positioned correctly to the raised rib position inside the battery compartment) Step 5 Replace cover and screw in firmly. Due to the double o-ring there will be resistance, make sure the knob is fully seated.
  • Page 3 Step 7 Pre- - - - flash set flash set flash set flash set- - - - up. Your camera’s pre-flash may be set from zero pre-flash up to as many as four. To determine your camera’s setting, first turn on the Strobe. You will note the red LED is defaulted from the factory to the bottom light (0 positions).
  • Page 4 Optional Fiber Optic Cable Kit (Model No. UXDS-FOC) can be purchased from ULTRAMAX online store or thru it’s Authorized Dealers.