Generally speaking, a distance of 0.5 m (1.5 ft) from magnetic data carriers (floppy disks, audio and video tapes, bank cards, etc.) is sufficient; a distance of more than 1 m (3 ft) may be necessary with computer and video monitors. d&b 24C/24C-E Manual 1.2 en...
2.1.2. 24C-E cardioid column extender The 24C-E is a passive column extension to be attached directly to the 24C. The cabinet houses six 4” neodymium drivers, providing an extension of vertical directivity down by a further octave to 190 Hz.
2 kHz. At low and mid frequencies, the resulting polar pattern is almost omni-directional (dotted line). The cardioid patterns of the 24C and 24C-E show a much higher directivity resulting in much less energy radiated into the room (continuous line).
The following graphs show dispersion angle over frequency of a single cabinet plotted using lines of equal sound pressure (isobars) at –6 dB and –12 dB. Isobar diagram 24C horizontal Isobar diagram 24C vertical Isobar diagram 24C with 24C-E vertical 2.1.5. Directivity index (dB) d&b 24C/24C-E Manual 1.2 en...
1. At the rear, slacken the M6 hex head screw. 2. Slide the screw up or down to set the mark above the screw to the calculated value. 3. Carefully retighten the screw. HF beam set to DMAX/H = 12 d&b 24C/24C-E Manual 1.2 en...
/AWG 11). The cabinet uses the pin assignments 1: + and 2: —. Pins 3 and 4 are not connected. 24C-E cabinets are equipped with a fixed cable gland fitted with a 2-pole Mate-N-Lok mini connector. The extender is electrically connected through the 24C cabinet.
0 and –9. Positive CPL values create an adjustable low frequency boost (0 to +5 dB) and can be set when the system is used in full range mode without subwoofers. Frequency response correction of CPL circuit d&b 24C/24C-E Manual 1.2 en...
150 Hz - 17 kHz Max. sound pressure (1 m, free field) 126 dB (SPLmax peak, pink noise test signal with crest factor of 4) 24C frequency response, standard and CUT modes 24C loudspeaker Nominal impedance 12 ohms Power handling capacity (RMS/peak 10 ms)
Page 12
Power handling capacity (RMS/peak 10 ms) 125/600 W Components 6 x 4“ driver with neodymium magnet Connections Fixed cable gland with 2-pole Mate-N-Lok mini through 24C Enclosure Extruded aluminum, metal baffle and front grill Weight 7 kg (15.4 lb) Mounting...
4. Disconnect the input connector [I] and take off the top panel. 2. Preparing the 24C-E cabinet 1. At the rear of the 24C-E cabinet, slacken the eight fixing screws (set screws - #T15) of the connecting rails. d&b 24C/24C-E Manual 1.2 en...
Page 14
3. Joining the cabinets 1. While a second person renders assistance, insert the connecting rails of the 24C-E cabinet into the T-slot profiles at the rear of the 24C cabinet approx. 10 - 20 mm. 2. Reconnect the input connector [I].
Please dispose of this product according to the respective national regulations or contractual agreements. If there are any further questions concerning the disposal of this product, please contact d&b audiotechnik. d&b 24C/24C-E Manual 1.2 en...